0
What else can I help you with?
How can I replace tube lights with LED lights?
To replace tube lights with LED lights, follow these steps: Turn off the power supply to the tube lights. Remove the existing tube lights from their fixtures. Install LED light fixtures in place of the tube lights. Connect the wiring of the LED lights to the power supply. Turn on the power supply and test the LED lights to ensure they are working properly.
Headlights in Pontiac Sunfire will not turn on?
headlights and dash lights in 2001 sunfire wont turn on.
Why wont your parking lights turn off?
There are a number of reasons why your parking lights won't turn off. There could be a wiring problem in the system.
How do you hook up led lights to turn on when you turn the light on in a car?
you hook it in the trunk
My PSP wont turn on at all not even the lights and it wont charge whats wrong?
your battery probably died
Why wont the bright lights turn off?
multi function switch( turn signal, lites etc)
Why wont your 2000 corvette lights turn off?
you havent turend them off
Will the battery run down if parking lights wont turn off?
Of course.
94 F250 parking lights wont turn off replaced relays switch still wont turn off?
check for short to power in the circuit
1985 dodge ram the tail lights wont work with the lights on both turn signals blink when you turn on the drivers side and there are no brake lights with the lights on what could be the problem?
check your ground wire in the back
How do you replace LED lights?
To replace LED lights, first turn off the power source. Then, remove the old LED light by unscrewing it or pulling it out. Next, insert the new LED light by twisting it into place or pushing it in. Finally, turn the power back on to test the new LED light.
How to remove ballast for LED lights?
To remove ballast for LED lights, first turn off the power supply. Then, open the fixture and locate the ballast. Disconnect the wires connecting the ballast to the fixture. Remove the ballast and rewire the fixture to directly connect to the LED lights. Close the fixture and turn the power back on to test the lights.
