answersLogoWhite

0

The door latch may not retract when closing due to a misalignment of the latch mechanism, a worn-out latch, or a problem with the door strike plate. This can prevent the latch from properly engaging with the strike plate and securing the door.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

Door latch wont latch on pillar pin on a 1997 mercury mystique?

Defective door latch or Nader Pin needs adjustment


Why wont the car door shut?

sounds like a bad door latch mechanism.


On 1998 Monte Carlo Z34 the drivers side door wont stay shut Its not that the latch is down and needs to be flipped up the latch wont lock into place when the door shuts What can you do to fix this?

Try spraying the latch mechanism with WD-40. Work the latch a few times and then spray it again.


My Chevy cavalier door all of a sudden wont shut what should I do?

Just going by the question...I would say that the latch has gotten in "the closed door position". Be sure that the door is unlocked. With your finger lift out on the latch on the end of the door and use the door handle to "open" the door latch.


Car door wont close?

Try checking the latching assembly on the door. If it snaps shut before the door colses, it keeps the door from closing. With the door open, look at the assembly while pulling the door handle to open. Use a screw driver and snap the latch that holds the door shut down. It should pop back and reset. Worn out door hinge pins and bushings lead to poor alignment and damage to latch and striker pin.


How do you fix a door latch that's stuck and the door wont shut?

how do you fix a prosthetic leg that the release screw wont go all the way down in to the socket


Why does door on 1998 Pontiac Grand Prix wont close?

usually the locking latch in the door is in the closed position. try holding the handle in the open position and opening the latch manually.


How do you fix the latch on the drivers side Door wont stay closed on a 2002 Cavalier Z24?

It is probably not closing fully. Take a proper size torx socket and loosen the fasteners on both the striker and the latch. There should be some adjustment there. Once the catch can grasp the striker fully it will be secure........1930fcoupe


Your 2001 Monte Carlo door wont shut on the drivers side?

the door striker needs adjusted along with possibly the latch mechanism.


How can fix a door that wont close on a Pontiac sunfire?

If your car has been injured in an accident, there might be a lot of damage thatcan't be seen. Various body tweaks can stop a door from closing properly.If the door is just rusty and old, it might be sagging. Or the latch might be old and worn.I'd try to get with a body technician for an evaluation.


Car door wont open from inside?

The cable between the latch and the handle may be broken or needs adjustement to shorten the cable so that the latch will fully release.


95 aerostar the lock and latch works yet the handle wont actuate the rear door how the heck do you re open this?

Pull the inner panel and actuate the latch manually.

Trending Questions
What are the best application techniques for epoxy sealer on plywood to ensure maximum protection and durability? What is the recommended pocket screw size and depth for joining 3/4 plywood pieces together securely? How can I effectively reduce the presence of silica dust in my home? What are the best drill bits to use for replacing worn-out screws in furniture? How to clean a jacuzzi effectively and efficiently? How can I properly install a microwave vent in my kitchen? What are the benefits of using travertine for a kitchen backsplash? What are the benefits of installing a 2x6 tongue and groove ceiling in a home or commercial space? How can I prevent mold from forming around windows in my home? What are the benefits of using a radon concrete sealer to protect against radon gas infiltration in buildings? What are some unique design ideas for incorporating live edge wood rounds into home decor? What are the different types of paint sheen available for painting projects? What is the best technique for using a hole saw bit to drill precise holes in wood? How does the spray arm in a dishwasher help to ensure thorough cleaning of dishes? What are the recommended installation guidelines for a metal stud electrical box? Is twiddling your thumbs hereditary? Can a breaker be bad and not trip when there is an electrical overload? How can I prevent leaking SharkBite fittings in my plumbing system? What is the purpose of a wall sill plate in construction and how does it contribute to the structural integrity of a building? How does a thermostat control the temperature of an air conditioner?