The microwave door may not close properly due to a misaligned door latch, a broken door hinge, or debris blocking the door from closing. It is important to check these components and clean the door area to ensure proper closure and safe operation of the microwave.
Access in rear door panel, allows you to lock/inlock rear door.
All bakugan will close, but some just need time to figure out how to close them. Like when I was trying to close my Mutant Taylean.
Close the door but first put a chemical by your do so they wont bring friends.
try to close it then never use it ...if i could keep it closed i wont open it again i think it has something to do with the mechanics in the door itself
You should first see a hair dresser who can put the weave in properly, then you wont have that problem
Assuming that your other doors lock and open properly check the solinoid for the drivers door.
usually the locking latch in the door is in the closed position. try holding the handle in the open position and opening the latch manually.
needs electric motor located underneath glass, behind door panel.
if your door wont close then i would look at the "eyes" but if it wont open or close check the wires take it wall unit off and make sure the wires are hooked up. I just learned a costly lesson and that you need to check the power. Are your red beams lit up? Check your trip switch. That's a $60 lesson and I hope I can save someone else a service call perhaps.
Fod product? Spray the door latch assembly liberally with WD-40, operate the door a few times then spray with a silicone spray
All rough openings for doors or windows should be as close as possible to plumb and square or your door or window wont be able to be installed properly. As long as you have enough room in the opening to iinstall it square and plumb it'll work fine but if your opening is way out of true, even if you install the window level and plumb it just wont look right.
as like the key wont turn or the door is just stuck? if so id try a lock smith cuz it might have to be drilled out. if the door is stuck just tug it hard sometimes integra doors bend easily so they dont close right