The toilet flapper may not close properly due to wear and tear, misalignment, or a build-up of debris preventing it from sealing tightly.
On the inner rim of your toilet where the water flushes out from the cistern, if these small holes are blocked it wont make the right angled pressure to flush a toilet
Yes that is normally the problem with a blockage
You shortened the chain too much. Make it longer a link at a time till it works.
All bakugan will close, but some just need time to figure out how to close them. Like when I was trying to close my Mutant Taylean.
You should first see a hair dresser who can put the weave in properly, then you wont have that problem
IF the bolt is properly installed, are you trying to close the bolt on a cartridge? The Mauser is designed to feed from the magazine- if you single load a cartridge, the extractor may not fit over the rim.
If your toilet bowl isn't fully flushing, it could be due to a few issues. Check for clogs in the trap or drain line, as even partial blockages can affect flushing power. Additionally, inspect the flapper valve to ensure it's sealing properly and that the flush mechanism is functioning correctly. Lastly, consider whether the vent pipe is obstructed, which can affect drainage and cause poor flushing performance.
You have to clog the toilet with toilet paper to have the janitor come and then you can grab the nickel
yes but it wont be as effective as tolet cleaner
You haven't unclogged your toilet yet.
Is it plugged in properly
It needs a new washer in it.