Go to the road site after it rains. Take a 2"x2" wooden stake with a flat (not sharpened) end and see how far you can drive it into the ground before it starts to break up. Should be at least 6 inches, more like 12. Convert that number into feet (9 inches would be 0.75 feet), this is how deep the road bed needs to be.
Take the road width X length X depth for volume in cubic feet, divide it by 27 for the number of cubic yards, and multiply it by 1.5 tons (the average) for the number of tons of gravel. Call the gravel supplier and ask for the delivered price for "number 1s and 2s" and for "crusher run" in the quantities you come up with.
You can figure that it will be half and half, the bottom being 1&2s, and the top half being crusher-run.
So: if you can pound the stake in 12 inches and the driveway will be 10 feet wide by 40 feet long and the delivered price for 1&2 comes out to $22/ton and crusher run is $20/ton than:
10 X 40 X 1.0 = 400 cubic feet,
400 CF / 27 = 14.8148 ...cubic yd
15 CY X 1.5 = 22.5... Tons
12 Tons X $22 = $264
12 Tons X $20 = $240
$264 + 240 = $504.00
Keep in mind that this is only for the gravel and the price/ton is dependent on the quantity purchased. You may be able to buy full truckload quantities for the same price as partials. Labor and the equipment rentals are fully dependent on site conditions. This is the proper quantity for a long-lasting road bed. You could make a very temporary road by spreading 3-4" of crusher-run on top of the grass.
call home depot. THey can give you an estimate.
In Malaysia, it cost RM20-30K to build a road of 100m in length.
Gravel is typically made from a mixture of small rock fragments and sand. These fragments can come from various sources such as crushed stone, limestone, or granite. Gravel is commonly used in landscaping, construction, and road building.
Car Wheels on a Gravel Road was created on 1998-06-30.
Some common minerals used for road building products include aggregates (such as crushed stone, gravel, and sand) for the base and asphalt for paving. Other materials like limestone and granite may also be used as construction aggregates in road building.
Limestone is used as a building stone, is cooked to make cement, is crushed to make road gravel, fill, and soil conditioner for agriculture.
And can police pull you over for driving on a gravel road, with a dirt bike?
It is paved for the first 30km, and gravel the rest of the way to Mountain Aire Lodge, the Forestry Trunk Road or Ya-Ha Tinda. The gravel road is quite wide as there is lots of oilfield trucks that use it routinely.
A road with ice will have more friction than a road with gravel or a plain road. The presence of ice reduces the grip between tires and the road surface, resulting in decreased friction and potentially hazardous driving conditions. Gravel can also reduce friction compared to a plain road, but typically not as significantly as ice.
Yes, you can pass on a gravel road as long as there is enough space to safely maneuver around the other vehicle. It is important to be cautious of loose gravel, potholes, and other potential hazards while passing.
Yes, road bikes can go on gravel paths, but they may not perform as well as bikes specifically designed for off-road terrain. Riders should use caution and be prepared for a bumpier ride on gravel surfaces.
A road bike is designed for smooth pavement and high speeds, while a gravel bike is built for rough terrain and off-road adventures. Gravel bikes have wider tires, more clearance, and a more relaxed geometry compared to road bikes.