answersLogoWhite

0

What else can I help you with?

Related Questions

Is a parking garage a light hazard occupancy?

Automobile parking garage Ordinary Hazard Group 1


3 WHAT is the Minimum Density for Automatic-Sprinkler Piping Design in light hazard occupancy?

0.10 gpm over 3000 square foot area.


What is occupancy expense?

Occupancy expense. Expense relating to the use of property. Examples: rent, heat, light, depreciation, upkeep, and general care of premises occupied.


How does the hazard light circuit work?

signal light


How do occupancy sensing light switches contribute to energy efficiency in buildings?

Occupancy sensing light switches help save energy in buildings by automatically turning off lights when a room is unoccupied, reducing unnecessary electricity usage.


93 Mitsubishi Eclipse - Turn light works fine Emergency Hazard does not Why?

the hazard light flasher relay is bad


How do you turn off your hazard lights that are stuck on?

Pull the hazard light fuse.


How do you fix the hazard light switch on a 97 Crown Victoria?

Remove the wiring harness from the back of your 1997 Ford Crown Victoria hazard lights switch. Remove the hazard light switch retaining screws. Reverse the process to install your new hazard light switch.


What is a hazard light on a car?

A Hazard light on a car is nothing more then all 4 blinkers going at the same time. Hope This Helps.


Diagram for 2002 Honda Accord hazard light switch?

hazard switch dont lights on


How many fire extinguishers should be in a house?

First determine the total square footage of both floors. Second, determine the hazard occupancy (low, moderate, or high) by reading examples written in the NFPA10, 2007 Edition, Standard For Portable Fire Extinguishers on page 10-23. If you are installing 10 lb. ABC Dry Chemical extinguishers (the most common type and size), most of them are UL rated at 4-A. A 4-A extinguisher will protect the following: low hazard occupancy - 11,250 sq. ft. ;ordinary hazard occupancy - 6,000 sq. ft. :high hazard occupancy - 4,000 sq. ft. Next divide your total square feet by the square feet of the occupancy hazard and you have your MINIMUM number of 4-A rated fire extinguishers required. You may have to add extinguishers due to the building layout. From any place in the building, you have to be able to walk to a fire extinguisher in no more than 75 feet (75 foot maximum travel distance). Lastly if there are any special hazards (computer room, electrical room, flammable liquids, etc.), they should be protected separately in addition to the building's fire extinguishers.


Where is the Audi A3 relay for the indicators?

It's built into the hazard light switch. The hazard light button will slide out, with the relay (small box) attached.