answersLogoWhite

0

The way to measure circuit all type series , and paraller also how would they look on a bread broad

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What is a complex circuits?

A 'complex circuit' is a category of electric circuit that encompasses any circuit that is not just a series circuit, a parallel circuit, or a series-parallel circuit. An example of a complex circuit is a bridge circuit.As you can see, such circuits are not necessarily complicated themselves; its just that they cannot be analyzed using only ohm's law and the power formula, but instead require more complicated methods like Theveninization, Kirchhoff's laws, etc. to be analyzed correctly.


How do you measure resistance in series circuit?

Using an Ohmeter open either end and follow above advice


To find the current in a complex circuit it is necessary to know?

the source voltage and the total impedanceAnswerA 'complex circuit' describes a category of circuit that is neither series, parallel, nor series-parallel. A relatively-simple example of a complex circuit is a Wheatstone Bridge. You cannot analyse or resolve a complex circuit using the techniques used to analyse and resolve series, parallel, or series-parallel circuit. Instead you must use one or other of the various electrical theorems. For example, to determine the currents flowing in a Wheatstone Bridge circuit, you could use Kirchhoff's Laws or Thevenin's Theorem.


How can I accurately measure amps on a 240V circuit using a multimeter?

To accurately measure amps on a 240V circuit using a multimeter, you need to set the multimeter to the current (amps) setting, then connect the multimeter in series with the circuit. Make sure to follow safety precautions and consult the multimeter's manual for specific instructions.


What is a measure of current flow?

Current flow is typically measured in amperes (A), which represents the rate of flow of electric charge through a circuit. It can be measured using an ammeter, which is connected in series within the circuit to measure the current passing through.


Would a bedroom be wired using a series circuit or a parallel circuit?

A parallel circuit


How to measure current?

To measure current, you would typically use a multimeter set to the appropriate current measurement range. First, ensure the circuit is off, then connect the multimeter in series with the part of the circuit you want to measure the current flowing through. Turn on the circuit to get a reading of the current flowing through that part of the circuit. Remember to set the multimeter to the correct range for the expected current to avoid damaging the meter.


Do You measure current across a circuit?

A current flows through, not across, a circuit. And, yes, you can measure it using an ammeter.


How do you write a sentence using parallel circuit?

This parallel circuit should actually be in series.


Using a cathode ray oscilloscope how do you measure the current in an electric circuit?

Cathode ray oscilloscope(CRO) is a device used to see the voltage across a particular element of your circuit and the wave form can also be seen on CRO. But you actually cannot measure the current using CRO as it is meant to give the voltage levels across any element in eletrically enegized circuit. however Digital Multimeter can do this job. But while using DMM to measure current one thing should be kept in mind that your circuit should be linear so that if you break the circuit to find current in series the current could not change in circuit.


How can you measure electric potential and electric current?

Potential . . .Always measured as a potential difference between two points.The most practical way to do that is with a voltemeter connectedin parallel with any circuit between the two points.Electric current . . .The most practical way to measure current is with an ammeter connectedin series in the path of the current.


What is the best way to determine how energy moves around in a circuit?

The best way to determine how energy moves around in a circuit is by using Kirchhoff's laws and Ohm's law to analyze the flow of current and voltage in the circuit. These laws help to understand the relationship between the different components in the circuit and how energy is transferred between them.