The location of the switches depends on what chassis the bus is manufactured on. They may be attached to the stalk switch, or on the dash.
The "trip odometer" on the dashboard doubles as a dimmer. So, the solution to no lights inside the Toyota Sienna is to turn the trip odometer up to turn the lights back on.
To reset, with the ignition off, hold in the trip reset button, then turn the key to position 2 so that the dash lights come on, and the inspection message will change to 4 flashing dashes (----). release the trip button. Job done.
Probably not. They check your dash lights for your turn signals.
You turn the trip odometer button on the dash.
To turn off inspection light on a 2005 Holden Barina, press down the trip reset. Then place the key into the ignition and turn to first stop while holding down reset for 10 seconds.?æ
Drivers are required to perform a "pre-trip" inspection of their vehicle at the beginning of each day before hitting the open roads. The inspection requires checking for proper air pressure in all tires, checking the air brake systems, checking that all lights and turn signals are operational, etc.
the slender rod that projects out from the tachometer, which is pushed to reset the trip odometer...when you turn it, the dash lights brighten or darken.
You use the reset trip button. Turn it to the right to increase the light or left to decrease. CB
I've researched this on the Internet and apparently the trip odometer button also serves as the dimmer for the dashboard lights. If you turn it (anti)-clockwise, your dash lights should come on. Its mentioned obscurely in the manual.
this is sooo easy.use the trip odmomiter knob but instead pushing it to reset to "0" turn it either to adjust lights
yes
no all vehicals from all direction are to stop and wait for the bus to turn their lights off and leave.