I had a 28 volt motor armature and field rewired,it now turns the wrong way,the technician says it has the wrong commutator installed,,and cannot find a new one.
check for spark, compression and wiring It is possible that the filter was installed backwards check to see if the flow arrow on the filter is facing the right way.
All household wiring uses alternating current. Only a universal motor that has a brush and commutator will run on both AC and DC as long as the voltages are the same as the nameplate states.
Yes you can diagram the wiring of an electric nike
A. J. Coker has written: 'Questions and answers on automobile electrical systems' -- subject(s): Automobiles, Electric equipment 'Electric Wiring' 'Electric wiring (domestic)' -- subject(s): Buildings, Dwellings, Electric apparatus and appliances, Electric equipment, Electric wiring, Handbooks, manuals, Installation, Interior Electric wiring 'Questions and answers on electric motors' -- subject(s): Electric motors
The commutator has two functions: (1) it enables current to pass to the external fixed wiring from the rotating armature, and (2) it is a rotating rectifier, which converts the a.c. voltage generated in the rotating armature, to a d.c. voltage.
Geoffrey Stokes has written: 'A practical guide to the wiring regulations, BS 7671' -- subject(s): Electric apparatus and appliances, Electric wiring, Electric wiring, Interior, Handbooks, manuals, Installation, Insurance requirements, Interior Electric wiring
A meter runs backwards when the direction of the electric flow in the circuit is reversed, causing the meter to register a negative reading. This can occur due to incorrect wiring, a malfunction in the meter itself, or when tampering is involved. Additionally, in some cases, a significant electrical load on the system can create conditions where the meter appears to run backwards.
electric seat wiring
Issue was found to be a tack in the wiring harness under the floormat, damaged the red/blue wire.
Replace the wiring that was burnt.
On the 3100 engine it is located between the master brake booster and the rear head of the engine on driver's side. It has a wiring connector on top and EGR is held on by two 10mm bolts. Can be installed backwards if not careful.
show me the batte ry wiring