Red flashing lights above the motorway indicate that drivers should be aware of a serious hazard ahead, such as an accident, road closure, or other emergency situation. These signals typically instruct vehicles to slow down and prepare to stop or change lanes. It's important for drivers to heed these warnings to ensure their safety and the safety of others on the road.
There is a small black button hanging down just above gas peddel under your dash to reset this problem. You have to hold it in till you hear all the door locks reset ,then your lights will stop flashing.
what is the name for a flashing above a window
you have to shoot the red and green flashing lights but you only shoot them when green. When all are green below the lights are lines with dots above and below them and you have to shoot each line to break them. there you go!
In the A4 it's not a warning light, it should actually indicate that your lights are on.
The highest motorway in the UK is the M62 near the boundry between Yorkshire and Lancashire which reaches 372 metres (above ordnance datum)at it's peak. == ==
The potential risks associated with flashing above windows in a building include water leakage, moisture damage, and potential structural issues if not properly installed or maintained.
When there is a flashing above a window, it is important to ensure that it is properly installed and sealed to prevent water leakage. Additionally, it is recommended to regularly inspect the flashing for any signs of damage or wear and tear, and to promptly repair or replace it if needed. Properly maintaining the flashing can help prevent water damage and potential structural issues in the building.
This means that your indicators or hazzard lights are turned on, OR if you are travelling over rough surfaces such as corrugations at a speed above 40km/h, there is some sort of inbuilt warning device that tells everyone you could be out of control. To turn them off you need to stop and turn the engine off.
you pick up the bombs he drops then get above him. when it starts flashing drop it
Warm air currents over a motorway can be caused by the heat generated from vehicles, which warms the air above the road surface. This warm air then rises and creates a thermal air current. Additionally, the design of the motorway, with barriers and structures, can also influence the movement of air and create pockets of warm air.
The brake indicator light tests continuity to your brake lights and activates if continuity is broken. This means one of the bulbs is out or there is a problem in the wiring to the lights. The light also comes on when you start your car and stays on for a few seconds along with the flashing "check" signal on your dash. If you wait or push the check button above your rear view mirror the lights should go out. If the brake indicator light doesnt go out check your brake lights and make repairs if necessary. The light should function correctly after the bulb is replaced or wiring is repaired. If not you may have a malfunction in your active check control system wich is behind the panel of lights above your mirror.
There are three, if it is in the middle at the bottom of the row of indicator lights then its the check engine light. If it is above the fuel gauge then its either the low fuel light or the abs light.