Stop light sensors are a loop of wire that is buried in the pavement and controls the traffic light. The sensors are able to detect the traffic that is waiting at the light.
Check your tyre pressure is correct then drive for about a few minutes after that the red stop light and sensor should go out.
Stop light switch? Usually located at the upper end of the brake pedal under dash area
Stop spinning the wheels or get the tire speed sensor that is faulty replaced.
it will randomly stall at the stop light
If you are referring to the stop light switch,it is under the dash near where the brake pedal pivots.When you push on the brake pedal, the stop switch pops open and completes a circuit to the stop light lamps.
In my 2004 GMC Canyon, the ambient light sensor is mounted at the right side of the dashboard. It is mounted below the dashboard and has a lens on the surface so that it can measure the ambient light that reaches the sensor through the windshield.
check the crank sensor
this is caused by the sensor tripping in the light sensor to see what causes this you must diagnose it with a computer and see what fails in it.
I think you need a speed sensor
yes..a bad oxygen sensor can/will make your car stall at idle speed
a light sensor is movement is made this triggers off the sensor which turns of the light
a light sensor is movement is made this triggers off the sensor which turns of the light