0
What else can I help you with?
Why Blower fan not working in Renault scenic?
Faulty switch, faulty wiring, blown fuse, burnt out motor are some of the reasons it may not be working.
What if the check engine light doesn't come on?
Burnt out bulb, faulty wiring, failed computer
Why did the windshield wipers stop working on cavalier?
either your motor burnt out or you have a faulty switch that turns them on. Or check the fuse
Why might a car's seatbelt-not-on dashboard light not work?
The bulb could be burnt out, there could be a wiring problem, or the module could be faulty.
Why my car is overheathing?
Ith low on coolant or has a sthuck closed thermostat.
Turn signals not working on a 92 mercury marque?
A burnt out signal bulb, a faulty blinker relay, a faulty blinker switch, a loose connection or a broken wire are all things that can cause the turn signals not to operate properly.
Why Starter work but engine don't start?
there is many different answers to thisNo spark ex. foiled spark plugs, faulty coilNo compression ex. bent valves, burnt pistons, compression ring missingNo fuel ex. clogged fuel filter, faulty fuel pump, faulty injectors
Why is the light not turning on?
The light may not be turning on due to a burnt-out bulb, a faulty switch, or a problem with the electrical wiring. Check these components to determine the cause of the issue.
What are the signs of a faulty lava lamp?
Signs of a faulty lava lamp may include the lava not flowing properly, cloudy liquid, or the lamp not heating up sufficiently. Additionally, if the lava lamp is making strange noises or has a burnt-out bulb, it may indicate a problem.
How do you fix the starter on a 1999 RAV4 Toyota when it continues to run after the car starts?
You just have to replace the starter as it's no good..the safety retraction switch is either burnt out or faulty
How do you know when you got a burnt valve in a 2000 crown Victoria?
The engine will run rough, and not caused by a faulty spark plug. Best to have a compression check, dry and with oil. This will tell you.
What is the reason why windsreen washers dont work?
The most common reasons are:1) burnt out pump motor 2) Disconnected or cracked hose someplace some place 3) Burnt out fuse 4) Burnt out/broken switch 5) Bad or broken wire between switch and pump motor 6) Empty reservoir 7) plugged up nozzle Check in this order: 1) Full tank 2) All hoses are connected and not cracked 3) Stick a needle or fine drill bit into all nozzle openings to make sure they are clear 4) Check for burnt-out fuse 5) Check pump motor to make sure it operates 6) Check switch to make sure it is not burnt out/broken 7) trace wires pith ohm meter to make sure it is conducting and not broken anyplace between power source and switch, or switch and motor connector.
