0
What else can I help you with?
Before you touch a wire in an appliance how should you make sure that it is NOT hot?
You can use a wire tester to determine if a wire is live. You can also touch the positive wire on the ground wire, if the wire produces a spark it is live.
Does it matter which side of the outlet the black wire is connected to?
Yes, it does matter which side of the outlet the black wire is connected to. The black wire is typically the hot wire and should be connected to the brass-colored screw on the side of the outlet. Connecting it to the wrong side could result in electrical hazards or malfunctioning of the outlet.
Why should a person never touch another person who is in contact with a live wire?
You should never touch a person in contact with live wire because the electricity will get run thru the body ad also get to you.
Should you attach the ground wire to the black wires?
No, the ground wire should be attached to the green or bare copper wire. The black wires are typically live or hot wires and should never be connected to the ground wire.
Should neutral wire of lamp be connected to the 3amp or the 6 amp side of a canopy switch?
You should never switch the neutral wire. The neutral of the appliance should be connected directly to the neutral wire leading to the service panel neutral bar.
Should 230Volts exits between live wire and protective earth?
yes
A fuse should be conected between?
A fuse should be connected in the live wire, before reaching the appliance.
Does the live wire from the ignition key go to the bat terminal and a live wire from the starter go to the tach terminal on a hei distributor for 350 Chevy in a boat with non standard wiring?
You do need a switched live to the bat terminal, but not to the tach terminal. The tach terminal is the negative side of the coil, the bat terminal is the positive side of the coil. Normally the tach terminal is for the green wire from the tach.
How do i check to see why my Rear speakers are not working in 2001 blazer?
take the speaker out and run 2 wires from the speaker one on positive side and one on the negative side the use a 9volt battery and touch one wire to each side the speaker should make a popping sound moving either up or down depending on which wire you have where. if you touch the positive wire on the positive side of the battery it should move out and if reverse should move in. if it does not do anything the speaker is blown.
What is the most common way of making an electrical connections?
The most common way of making an electrical connection is with a device called a wire nut. Solid wire connections should be twisted together with a pair of pliers before installing the wire nut to hold the splice tight. Twisting stranded wire together with a pair of pliers does not allow the wire nut to grip the wires as tight as it should. Stranded wire should be held together side by side (in parallel) and let the wire nut twist the wires together to make a solid splice connection.
What is the most common way of making electrical connections?
The most common way of making an electrical connection is with a device called a wire nut. Solid wire connections should be twisted together with a pair of pliers before installing the wire nut to hold the splice tight. Twisting stranded wire together with a pair of pliers does not allow the wire nut to grip the wires as tight as it should. Stranded wire should be held together side by side (in parallel) and let the wire nut twist the wires together to make a solid splice connection.
How do you convert don't touch live wire to passive form?
Live wire is not to be touched. or Live wire touch not..haha
