yes
I called our pool supply store after we found a mole in our pool and their advice confirmed what I had already believed. You need to shock your pool. Rodents carry rabies, among other things!
You do not need to remove it.
3800 gals of pool water shock it with 1 gal bleach
Remove the dead animal skim any floating materials from the top of the water vacuum the pool floor, then shock the pool with an extra strong dose of chlorine. The pool should be ok the next day.
The pool is probably contamiated now, because there/is a dead carcass in it. First remove the squirrel, and dispose of it. Then you will need to cleanse the pool, a bleach solution should do the job. I would try and figure out why the squirrel fell in the pool, but whatever or you can call animal control like your supposed to Not all municipalities would send someone to remove the dead animal. After it is removed you will need to "shock" the pool with the chemicals that are ordinarily used (chlorine). The amount used depends upon the size of the pool, calling a store that handles pool chemicals or the city or county health department can obtain the information needed to solve the problem.
shock it
You need to scoop it out then super shock the pool and run filter. There is a chance of E Coli bacteria so you need to make sure you shock the pool well
You should shock your pool upon finding a critter in it...I have had 2 chipmunk fatalities in my pool and a squirrel fatality and had to shock every time because the little guys can carry bacteria Good Luck
Is the pool full or empty? Depends how long they were in there. If it was just overnight, no big dal. If it was a week, I would shock the pool. Pool Masters.
Salt pools still require weekly shock maintenance, but not near the amount that a chlorine pool would need. There are Salt Pool Shock Treatments out there for your particular pool setup.
Backwash first then shock. If you shock and then backwash you will be throwing away the shock you just put.
To use pool shock effectively for maintaining clean and clear water in your pool, follow these steps: Test the water: Use a pool water testing kit to check the chlorine and pH levels in your pool. Calculate the amount of shock needed: Refer to the instructions on the pool shock product for the correct dosage based on your pool size and current water conditions. Dilute the shock: Dissolve the pool shock granules in a bucket of water before adding it to the pool. This helps prevent staining or damage to the pool surface. Apply the shock: Pour the diluted shock solution around the perimeter of the pool while the filtration system is running. This ensures even distribution of the shock throughout the water. Wait and test: Allow the shock to circulate in the pool for several hours or as recommended on the product instructions. Test the water again to ensure the chlorine and pH levels are within the desired range. Repeat if necessary: If the water is still cloudy or algae persists, you may need to shock the pool again or consult a professional for further advice. By following these steps, you can effectively use pool shock to maintain clean and clear water in your pool.