answersLogoWhite

0

Unplug the connector wire. Take the tensioner spring loose for the deck belts, then slip the belts off of the pulleys in the front of the mower right below the engine. There is a single 5/8" bolt than comes out vertically on the bottom of the pto clutch. Take that bolt out and make sure the 2 belts are slipped off of the pulleys and the pto clutch should drop right down. Make sure and remember how the spacers and the square slip pin goes in the pulley assembly above the pto clutch. Install back in the reverse that you removed it. P.S. It also helps give you more room to work if you lower the mower deck all the way "down".

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is a manual pto on a john deere d 130?

The manual pto is the switch used to engage the mower deck.


How do you replace a john deere 325 drive belt?

remove deck...remove pto clutch and both idler pulleys and u should be able to put on


How much horsepower does the John Deere 1010 have?

36 at the PTO, 30 at the drawbar


Do 3130 have 2 speed PTO?

The John Deere 3130 tractor typically comes equipped with a single-speed PTO. However, some models or configurations may offer an option for a two-speed PTO. It's best to consult the specific model's manual or a John Deere dealer for precise information regarding the PTO options available for that particular tractor.


How do you install a PTO clutch on a John Deere 345 lawn tractor?

To install a PTO clutch on a John Deere 345 lawn tractor, first disconnect the battery to ensure safety. Remove the mower deck and any necessary covers to access the clutch assembly. Unbolt the old PTO clutch, then position the new clutch in place, securing it with bolts. Finally, reconnect the wiring and reassemble the mower deck before reconnecting the battery and testing the clutch.


How much horsepower does the John Deere 1010 row crop have?

36 horsepower at the PTO and 30 at the drawbar


What is the horse power of a john deere 8260 l?

260 engine hp (216 PTO hp)


John deere x595 want PTO to stay engaged when you reverse Can you bypass this when using mower?

Yes pull pto up when pressing reverse pedal pto remains engaged. release when moving forward.


What year was the John Deere 2305 made?

The 2305 john deere was a new model starting in 2005 It would be sold with the front bucket it is a 23hp yanmar engine 4wd and a 18hp pto


How muche horsepower does a John Deere 2040 have?

A 4040 has 77 drawbar horsepower and 91 PTO horsepower.


Where is the serial number on a john deere 755 trator?

The serial number plate is at the rear, under the PTO shaft.


Is a John Deere 318 2000RPM rear PTO the same shaft size and spline number as a 6 spline 540RPM standard PTO?

No, it is not. A 2000RPM rear PTO shaft has a 1 inch by 15 spline yoke