0
What else can I help you with?
What is the tighting torque for a 1995 ford mondea?
Torque for what component?
How do you replace rear wheel bearings on a 1991 Dynasty And how tight do you torque the wheel bearing nut?
you have to press it out and press the new one in just make sure you tighting it real good
Which 54H60-91 propeller subassembly transmits engine torque to the propeller blades?
Barrel Assembly
What would cause a Nissan Altima transmission to hesitate when putting it into drive or reverse?
I was told by my mechanic that the transmission hesitating after putting it in drive after reversing is a sign of the transmisison dying. ---------- Check transmission fluid. When the fluid is low there is not enough in the torque converter, so when you go to reverse or drive you have to rev the engine before it moves to compensate for less fluid in the torque converter.
What is the oil filter torque on 2009 Chevy Malibu?
there is no torque on the oil filter!! when putting back on tighten the filter hand tight as much as you can.
How do you know if you've torqued it down enough?
You'll need a torque wrench and the torque specifications for that bolt .
How much torque should be used when putting tires on an 87 300ZX?
60 foot pounds
How much torque does a V8 have?
Not nearly enough info to answer that question.
What is the relationship between number of propellor blades to the horse power of the ships engine?
Without delving into fluid dynamics or excessive physics, a simple explanation: The relationship lies in the specifics of an individual ship. Most ships run diesel engines, which provide large amounts of torque at low rpm (more fuel economical). Though any sized prop will move a ship, more blades will produce a higher thrust, which is more efficient when using an engine with high torque. For commercial purposes gasoline engines are sometimes used to allow higher rpm. In this situation a prop with high thrust (more blades) will be less efficient, as the engine would not produce enough torque to redline (top speed). Note: Diesel fuel will not produce enough vapour below about 122F or 50C to ignite, however gasoline will and is commonly regarded as being more dangerous for use on board vessels.
What force is applied in working of a fan?
In a fan, the force that is applied is typically generated by an electric motor that drives the rotation of the fan blades. This motor creates a torque that spins the blades and moves air through the fan. The movement of air is then produced by the fan blades as they push or pull the air in the desired direction.
Where can you find a wheel and axle on a fan?
A wheel and axle can be found in the motor of a fan. The wheel is the rotor of the motor, which spins around the axle, transferring rotational motion into the blades of the fan. This mechanical advantage allows the motor to generate enough torque to move the fan blades and create airflow.
Is it necessary to torque a class 1 hitch?
Yes, any bolt that has a torque specification should be torqued for safety concerns. Not enough torque on the bolt can allow it to loosen up and too much torque can cause the bolt/nut thread to fail.
