If you are talking engine oil drain plug, it may be located in two locations. On the L/H or R/H side at the bottom of the engine there will be (or should be) a small pipe with a drain plug attached to it, usually this is located by the engine oil filter. I can't remember off hand where the trans oil drain plug is, but I know if you contact your local ( or closest ) JD dealer, they will be more than happy to tell you where the drain plug is for the trans oil, with no cost to you. Hope this helps!
john Deere 318 what oil in hydro does it take
The John Deere 318 with the serial number MOO318X31695 was manufactured in 1983. John Deere's serial numbers can help identify the production year, and in this case, the "MOO" prefix indicates it was produced in that year.
.18
1952 t0 1989
To drain the gas tank of a John Deere 318, first ensure the engine is off and cooled down. Locate the fuel shut-off valve, if equipped, and turn it to the off position. Disconnect the fuel line from the tank, directing it into a suitable container to catch the fuel. You may need to use a siphon or manually tilt the tank to ensure all fuel is removed. Always follow safety precautions when handling gasoline.
The model number M00318X372679 indicates that your John Deere 318 is from the year 1983. The "M00" prefix signifies it is a model made in that specific series, and the serial number helps identify the production year.
Right side of engine on rear
91" long, 5/8 wide
5/8 inch
Diagnostics needed for john deere f510 electrical system
probably the governor going bad
The John Deere 318 garden tractor typically weighs around 700 to 750 pounds (approximately 318 to 340 kg) without any attachments or additional equipment. This weight can vary slightly depending on specific configurations and modifications. It's designed for residential and light commercial use, providing a balance of power and maneuverability for gardening and landscaping tasks.