0
Under the RH wheel well next to the starter switch
What else can I help you with?
How do you replace a drive belt on a 38yard machine lawn mower?
How do you replace a mower deck belt on a stx38 hydro
Where can i find a John deere stx38 belt diagram?
Go to http://outdoorpowerinfo.com/repairs/deere_stx38_gear_drive_belt.asp for pictures and descriptions of installation of drive belt and deck belt for John Deere STX38 Tractor with black mower deck.
How do you install grass catcher for a john deere stx38?
i have a jd stx38 lawn mower with most of the grass catcher except the bags that actually stores the grass,debris. where can i find these bags and how to hook up thanks ,berry dunn lady3n@ec.rr.com
How do you change a mower belt on a stx38 john deere lawnmower?
Outdoor Power Equipment Website
How do you grease an stx38 black mower deck?
I believe that deck uses sealed permanently lubed bearings.
How can you tell what year a john deere stx38 riding mower was made id tag says m00stx8597946?
moostxc255457
Where are stx38 fuses?
The STX38 fuses are easy to find on a tractor. The fuses are located under the hood.
Why won't a John Deer STX38 riding mower start has new battery it won't click or turn over?
Once of the safety devices is engaged or the ignition switch is defective or you have a blown fuse. It is also possible the starter is bad.
What is belt length on john deer stx38 black mower deck?
The belt length for the John Deere STX38 mower deck is typically around 109 inches. However, it's always best to consult the owner's manual or check with a John Deere dealer for the exact specifications, as variations might exist based on the specific model or year. Proper belt maintenance is crucial for optimal mower performance.
How do you engauge mower stx38?
There is a small switch on the right fender close to the key switch. If it is still the original switch you need to pull it upward as you switch it.
How do you engage the mower for a John Deere stx38?
The STX-38 should have an electric clutch for the mower deck. The switch to engage it is on the right rear fender. It is a toggle switch. You will have to pull up on the switch and forward to engage the blades.
How do you repair brakes on a stx38?
To repair the brakes on a STX38, start by lifting the mower and securing it on a flat surface. Remove the wheel and check the brake pads for wear; if they are worn out, replace them. Inspect the brake linkage and springs for any damage or misalignment, adjusting or replacing as necessary. Finally, reassemble the components, ensuring everything is tightened properly, and test the brakes before using the mower again.
