0
What else can I help you with?
How many vertices does funnel have?
how many edges and corner of funnel
Is a funnel an incline plane?
yes
When you put a ping pong ball in a funnel and blow in the funnel why does the ping pong ball stay in it?
The reason the ping pong ball stays in the funnel when you blow in it is because of Bernoulli's Principle. This principle states that as the speed of a moving fluid (liquid or gas) increases, the pressure within the fluid decreases. When you blow in the funnel at a high speed, the pressure around the ball decreases. Then, the pressure from the outside of the funnel (because there is air pressure everywhere) pushes down on the ball at a lower speed, which would mean higher pressure, which causes the ball to stay inside the funnel. Mind you that the bernoulli's principle is based in the wind tunnel or venturri tube and the funnel is an example of a venturri tube, so that would further explain it.
The inverted funnel format is used by?
legal secretaries
When is the inverted funnel format used?
The inverted funnel format is usually used within legal documents. It is also known to be used by doctors but it can be used in any kind of business documents.
How full should a funnel be filled with solution in a filtration procedure?
In a filtration procedure, a funnel should typically be filled to about one-third to one-half of its capacity with the solution. This allows for efficient filtration without risking overflow or splashing. Additionally, leaving some space helps accommodate any potential foaming or bubbling that may occur during the process. Always ensure the filter paper is properly seated in the funnel to prevent clogging.
Why it is important to minimize the evaporation during the filtration of hot solution?
Because some of the compounds of the solution can disappear in the air by evaporation.To avoid recrystallization in the funnel. And rapid crystallization will occur if there is maximum evaporation.
What type of funnel will be used in the vacuum filtration step?
A Büchner funnel is adequate.
What is used to hold filter paper?
A filter paper is typically held in a funnel during filtration. The funnel is often placed in a ring stand or held by a clamp to support it during the filtration process.
When filtering why is it necessary not to overflow the filter paper that is seated in the funnel?
Overflowing the filter paper can disrupt the filtration process by causing liquid to bypass the filter paper or leak through the sides of the funnel, reducing the effectiveness of the filtration. It can also result in contamination of the filtrate with the solid particles being filtered out. Keeping the filter paper below its maximum capacity ensures that the filtration is efficient and the desired separation is achieved.
Why does substance remain in the funnel during filtration?
Substance may remain in the funnel during filtration due to clogging of the filter paper by fine particles, improper wetting of the filter paper before filtration, or insufficient pressure to facilitate the filtration process. Additionally, some substances may have a tendency to stick to the filter paper or be insoluble in the solvent being used for filtration, leading to retention in the funnel.
What is a funnel and what is its uses?
A funnel is a laboratory tool used for filtration or to pour convenient liquids or fine powders.
Function of the filter funnel?
The use is to separate as solid from a liquid by filtration.
What is filtratrion?
Filtration is separating a suspension using filter paper and a separating funnel.
How do you use filtration paper?
fold it in half make it a circle put it in a funnel
What method would be best for separating sand from a solution of potassium chloride?
One method for separating sand from a solution of potassium chloride could be filtration. The mixture can be poured through filter paper or a filter funnel, allowing the liquid potassium chloride solution to pass through while trapping the solid sand particles.
Why should you pour a solution around a stirring rod during filtration?
Pouring the solution around a stirring rod during filtration helps prevent splashing and the formation of air bubbles, which could disrupt the filtration process and potentially introduce impurities into the filtered solution. It also aids in maintaining a steady flow of liquid through the filter medium, ensuring efficient separation of the solid and liquid components.
