A thimble is a sewing tool and as a noun has no obvious antonym. It might be associated with thread or needle, but those are not then opposites necessarily.
An example of a sentence using the word "thimble" might be: A thimble is a tool used by seamstresses and tailors to help them push needles through fabrics.
Milliliters is the metric unit to use for the capacity of a thimble.
In order to read a micrometer, you will use the numbers on the thimble and on the sleeve. The numbers on the sleeve are broken down into 4 parts. Think of them as dollars with whole numbers and quarters. The numbers on the thimble can be represented as pennies, or ones. If the sleeve is at 9 3/4 and the thimble is at 4, the reading would be .979.
Use the millilitre (ml)
To read a micrometer, first ensure the instrument is calibrated and set to zero. Place the object between the anvil and spindle, then rotate the thimble until it gently contacts the object. Read the measurement by combining the main scale reading (on the sleeve) with the thimble scale reading (where the thimble aligns with the main scale). The main scale typically measures whole millimeters or inches, while the thimble scale provides fractional measurements, usually in hundredths of a millimeter or thousandths of an inch.
It is known as a thimble.
What is a thimble on a vernier scale?
Thimble Summer was created in 1938.
A thimble.
The illustrator of the Thimble Summer is Maginel Wright Barney.
Thimble has two syllables. The syllables are thim-ble.
Thimble Shoal Light was created in 1914.
are you sure this is a music question? i sewing thimble goes on your thumb
An example of a sentence using the word "thimble" might be: A thimble is a tool used by seamstresses and tailors to help them push needles through fabrics.
A typical metal thimble might weigh around 5-10 grams, while a plastic or silicone thimble could weigh less than 5 grams. The weight can vary depending on the material and size of the thimble.
The nest looked like a thimble made of twigs and dried grass.
The wire rope diameter should lay in the bottom of the thimble radius groove with out any space showing on the sides or bottom of the thimble groove. This way when tension is applied to the rope it will not deform the thimble's groove. In other words match the cable to the thimble.