forcing abrasives over work piece at higher speed for cutting . it is unconventional machining process .
In ordinary machining we use harder tool to work on workpiece , this limitation is overcome by unconventional machining. unconventional machining is directly using some sort of indirect energy for machining. Example : sparks, lasers, heat , chemicals etc.. applied in EDM ,laser cutting machines...etc
what is the woking principal of steam jet ejector? limitation of steam jet ejetor?
It is the height, width and length of a jet engine.
Jet Ratio: it is defined as the ratio of the pitch diameter (D) of the pelton turbine to the diameter of the jet (d). It is denoted by m and is given asm = D/d (=12 for most cases)
Water jet
we use water for maching in WJM, and abrasives in AJM.
Abrasive water jet cutting can cut aluminium, stainless steel and brass with no ternishing. It can also cut ceramic floor and wall tiles, granite, marble, slate and limestone.
In ordinary machining we use harder tool to work on workpiece , this limitation is overcome by unconventional machining. unconventional machining is directly using some sort of indirect energy for machining. Example : sparks, lasers, heat , chemicals etc.. applied in EDM ,laser cutting machines...etc
water jet machining process check out http://engineersguide.in/mech1.html
Abrasive water-jet cutting, is when one uses water jets for cutting and removing materials. The water jets may contain abrasive powder, and can be used to cut titanium, marble, and glass.
A forced draught is where the air flow comes directly from the fan to the object. Such as an hair dryer.An induced draught is where the air flow is induced {lit lead in} by a separate flow of air. For example, an abrasive jet would quickly wear out if the abrasive passed through the jet nozzle. the flow of abrasive is added (induced) into the air flow by a jet of clean air.If an air flow is corrosive or very dirty then an induced flow system would be appropriate.
An abrasive jet can cut half-inch thick titanium at the rate of 7 inches per minute.
it depends on what kind of jet it is. 737 jet: 200 747 jet: 500 757 jet: 280 767 jet: 290 777 jet: 550 787 jet: 350
Waterjet uses up to 60,000 psi pressure to project water streams through the cutting head. With the high pressure of the water, and abrasive particles (garnet) mixed in with the cutting stream, the waterjet is able to cut up to 12" thick materials.
Jet Jet (I bet on the wrong jet. Jet Pilot won it.
Jet, Jet, Jet I can almost remember their funny faces That time you told them you were going to be marrying soon And Jet, I thought the only lonely place was on the moon Jet, Jet, Jet Was your father as bold as the sergeant major? Well how come he told you that you were hardly old enough yet? And Jet, I thought the major was a lady suffragette Jet, Jet Ah Mater want Jet to always love me Ah Mater want Jet to always love me Ah Mater, much later Jet And Jet, I thought the major was a little lady suffragette Jet, Jet Ah Mater want Jet to always love me Ah Mater want Jet to always love me Ah Mater, much later Jet With the wind in your hair of a thousand laces Climb on the back and we'll go for a ride in the sky And Jet, I thought that the major was a little lady suffragette Jet, Jet And Jet, you know I thought you was a little lady suffragette Jet A little lady My little lady, yes, oh!
There is no actual answer, because a jet is called a jet because it has at least one jet engine.