0
Cotter Joint is used to transmit Axial Forces..... ie tensile force.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What does RJT mean on a thread?
Ring Joint Type
What type of motor is used for a robot arm joint?
servo motor
What is definition of fluctuating load?
The type of loads that vary continuously on the structure or a body are called fluctuating loads . for example traffic passing on a bridge applies different loads of varying nature.When load is fluctuating , the maximum stress level condition appears frequently . number of loading cycle is a count which tells that how many times the structure can bear maximum stress level.So fluctuating loads reduce the endurance limit.
What type of weld is it when the edge of one piece of metal is placed at ninety degrees on the surface of another piece of metal?
Two pieces of metal welded at a 90 degree angle is called a corner joint. Other common joint types: -Butt joint: two pieces of metal laid side by side and welded at the meet, essentially forming one sheet. -Lap joint: similar to a butt joint, but with overlap between the two pieces. -Tee joint: one piece is welded at a 90 degree angle to the second, but not at the edge (forming a 'T' shape).
How does an electromechanical relay work?
All electrical relays consist of two circuits. 1.. A control circuit that utilizes a control voltage with a minimum current to switch a 2.. Power circuit requiring much greater current. The advantage of using this type of circuitry is that the switches or sensors that control large loads can be very small, {i.e. pilot switches, limit switches, sensors, etc.}, since they are the control switching device that can be capable of switching loads up to 600 amperes. This arrangement allows a very small wire size for controlling large loads. Without the use of relays, switches that control larger loads would be very expensive and occupy much more space.
What type of material used for cotter joint?
why what type of material is used?which are the manufacturing companies?what are its standard dimension?Cotter jointThese types of joints are used to connect the end of a rod or bar to a shaft. The end of the bar has a hole in it and it is called a lug. The hole carries a shaft. This shaft is locked in place by a smaller pin that passes through the side of the lug and partly or completely through the shaft itself. This locking pin is named a cotter, which sometimes is also applied to the whole joint.The obvious example is on a bicycle where both pedal bars are separately locked by a cotter pin, on their common driving shaft having the sprocket wheel.Steel is the most common material used for this application. There are no specific manufacturing companies who make only cotter pins, nor are there any dimensional standards by which they are designed.
What type of waves do fluids transmit and why?
fluids usually transmit only what type of waves
How does a microprocessor transmit information?
transmit is a type of light ray. what type i dont know
What type of joint is the antlantoaxial joint?
This is a synovial joint. It is classified as pivot type of joint.
What type of joint is the acromioclavicular joint?
The acromioclavicular joint is a plane, or gliding, joint.
Type of joint found in your neck?
Pivot joint is the type found in the neck.
What type of joint is your wrist joint?
.
What type of joint is the most common type of joint?
Synovial joints
Which is not a type of human joint?
slider joint
What type are the waves that transmit sound?
longitudinal
What type of thing does not transmit sound?
Sound and vibration are transmitted by matter. So a vacuum will transmit neither.
Which type the joint is movable?
Pivot joint
