answersLogoWhite

0

vNeeds to be very hard, tough

vPoor thermal heat conductor

vIt needs to be able to drill through holes (strong)

vAbrasive

vIt can't dissolve

vNot conduct electricity

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What is another word for the tip of a drill?

Drill Head.


Is it true that nicks head could drill through a dimond?

no beacuse my head in not like a drill its like a pin


What kind of drill bit is needed for concrete?

Diamond Core Drill Bits are the best for concrete.


Why was the electric drill?

Because they needed something other than hands, to drill rock and dig coal.


How do you remove a nail after the head breaks off?

To remove a nail after the head breaks off simply drill through the nail with an equal sized drill bit.


Why was the electric drill invented?

Because they needed something other than hands, to drill rock and dig coal.


What size drill bit is needed to drill a propane orifice to produce 15000 btu 11 WC?

54


Is hand gloves needed while using electric drill?

No, gloves are not necessary while using an electric drill.


What size Phillips head drill bit should I use for drilling into metal?

For drilling into metal, use a Phillips head drill bit that is 1/8 inch in size.


How can I effectively drill out a screw in metal?

To effectively drill out a screw in metal, follow these steps: Use a drill bit that is slightly smaller than the screw head. Place the drill bit on the center of the screw head and drill slowly to create a pilot hole. Increase the drill bit size gradually until the screw is loosened. Use pliers or a screw extractor to remove the remaining screw.


How did the electric drill come to be invented?

Wilhelm Fein invented the portable electric drill in 1895.


How can I effectively use a drill bit to remove stripped screws?

To effectively use a drill bit to remove stripped screws, first select a drill bit that is slightly smaller than the screw head. Place the drill bit in the center of the screw head and drill slowly in reverse (counterclockwise) direction. Apply steady pressure and the screw should come out.