Basic what happens. Is with longer on time duration (pulse) you get higher burn rate. But a correct balance of on and off times is how you keep from wearing the electrode more than the part.
an increase in relative humidity will increase the Gas turbine output. and thermal efficiency. when the ambient tempeature is high at that time also if RH is high it will have a slight positive impact on GT output & Efficiency.
Following parameters affect injection moulding process. 1) nature of material (type of plastic) 2) rate of injection 3) size of the component being moulded 4) efficiency of machine 5) type of cooling method adopted 6) curing time in the mould
These machines can rough machine both sides, at the same time, of a blank to "near finish" or "finish size" on the thickness of a blank. This cuts the time spent finish machining on a more expensive CNC machining center to perform the more complex machining characteristics of the part. Unfortunately, this increases handling time, setup time, and adds another move and probably another storage point to the process.
Production rate of injection molding machine depends upon cycle time (total time that machine takes to produce a product in one cycle) and the number of cavities. For calculating cycle time, you must consider time for each phase that machine takes in one cycle. That phases are: Mold closing / clamp Filling Pack and hold Cooling and Recovery (40-60% ) Mold Open Ejection Add time taken by each phase. For example, this time is 15 seconds and the number of cavities are 2. So the production rate is 2 finished product per 15 seconds. You can increase your production by decreasing the cycle time. You can decrease cycle time by following some points: Keep wall thickness to minimum required for your product Ensure your machine is fine-tuned Ensure proper cooling system, injection pressure and injection speed is applied.
For AC motor, you can change motor RPM by changing its supply voltage or by changing supply frequency. For DC motor, you can change motor speed by controlling armatyre voltage or field current.
because each time your pulse rate may increase or decrease it depends on your movment
increase
It starts to deteriorate, but not for a long time.
(shiwwasuji@gmail.com)Duty Cycle DC is the ratio of pulse duration to the pulse repetition time periodDuty Cycle DC = pulse duration (t)/pulse repetition time period (T)Pulse Duration (t) = 0.008 x 2.5 ms
Resources will decrease while at the same time rot and disease will increase.
increase by one in tens place
reaction will increase
recovery time makes the pulse rate normal=)
Ø How drive works, Calculate time in one pulse.
If you mean how long do you take a pulse for? A Mintute.
Propagation time of any pulse is roughly the time needed for the leading edge of the pulse to travel from one point to another. It will be more accurate to say that the pulse is registered at a given point when its leading edge reaches half of the maximum value (amplitude) of the pulse. The propagation time of a sound pulse is equal to the distance between the measuring points divided to the sound velocity in the medium in which it propagates.
Yes; power= work/time, or work per time, measured in watts.