it allows flow only on one side... the return path (opposite flow ) not possible..
It's a one way flow control valve, which allowed flow in 1 direction and block flow from opposite direction.
You mean GLOBE valve and that would depend on the size of the valve and the maker
I would use a butterfly valve to set the flow and a pitot tube to measure it. Nexus Valve makes a good one and it is price competetive as well.
Never. Throttling will erode the valve seat and then the valve will never shut off completely.
Relief valve always position in the suction line in oreder to relief the extra pressure, while safety valve is always placed at discharge line to release excess pressure.I would take that one step further by stating that a " RELIEF VALVE" is one that is "meant" to be lifted off its seat, as opposed to a "SAFETY RELIEF VALVE" which is not!DIFFERENCE BETWEEN RELIEF VALVE AND SAFETY VALVE:1. Releif valve is applicable in the fluid system.safety valve is applicable in the gaseous system.2.Relief valve opening is directly proportional to the pressure rise.Safety valve opening is will happen at after reaching the setpressure.3.Mode of relif vlave line is again connected to the suction.But in the safety valve is just vent-out there is no connection tosuction.
A non-positive shut off valve is one that is controlled by the user. You hold down the valve to keep the water or whatever coming out, and when you want it to stop, you release the valve.
There is no difference between check valve and NRV, both are same
Nonreturn to zero, levelNonreturn to zero, invert
you probable have a fuel draining back to the tank try pumping your fuel primer then it should start almost straight away if so then you have a air leak or your nonreturn valve has gone on the fuel filter
Valve pocketing is when a valve is hammering the valve seat.mostly due to miss adjusted valve spring/wrong valve spring/to strong of a valve spring or valve stem to short.Makes the valve seat deeper.
tricuspid valve,bicuspid valve and pulmonary valve
A valve spring "keeper" or AKA a valve spring "retainer" is used to lock a valve spring to the valve.
# The PCV valve is located in the valve cover # Detach the hose from the valve then unscrew the valve from the valve cover
Spill valve is a overflow valve.
Ileocecal valve
The valve guide is a precise hole in the head that the valve stem slides in. The valve is retained by the retainer and two valve locks.
intake valve is bigger.
the triscuspid valve is the valve in a bathroom sink.