answersLogoWhite

0

Bank suction refers to the phenomenon where a bank or financial institution may withdraw or reduce its deposits from the central bank or other banks, typically in response to liquidity needs or regulatory requirements. This can lead to a contraction in the money supply and affect lending capabilities within the economy. It can also create a ripple effect, influencing interest rates and overall financial stability. The term is often used in discussions about banking liquidity management and monetary policy.

User Avatar

AnswerBot

3w ago

What else can I help you with?

Continue Learning about Mechanical Engineering

Does low suction pressure have an effect on reciprocating compressors?

At very low suction pressure, the suction valves of reciprocating compressor will not work and there will be no gas in the cylinder during compression stroke, resulting some damage to the suction valves. If low suction pressure trip protection is not provided there can be some abnormal damage.


What is the difference between suction lift and suction head?

Suction lift is only negative. Suction head is positive or negative.Suction head is the distance between the surface of the liquid being pumped and the centerline of the pump. It can be positive or negative, and it can be affected by pressure or vacuum on the surface of the fluid. A negative suction head is also called suction lift.Example 1: A D/A under 15 psig is set 20 feet above the feed pump the effective suction head is 54 feet. (15 psig is equivalent to 34 feet of water).Example 2: A Condenser hotwell under 28 inches of vacuum (Hg) is set 16 feet above the suction of a propeller pump. The effective suction head (lift) is -15 feet.* (28"Hg = - 31 feet of water)Example 3: A sump pump is set 4 feet below the surface of the well. The effective suction head is 4 feet.*Note: Suction lift is only effective to a maximum of 21 feet, and 15 feet for hot water depending on temperature and pump slip.


What is vapour binding?

when pressure on the suction side of the pump drop below the vapour pressure of the liquid, vapour forms. It's caused because of insufficient suction head, high suction lift, excessive friction head, or high liquid temperature.


What is a suction drier?

A suction drier is a device used in refrigeration and air conditioning systems to remove moisture and contaminants from refrigerants. It typically contains a desiccant material that absorbs water and filters out impurities, ensuring the refrigerant remains clean and effective. This helps to prevent corrosion and damage to the system's components, enhancing overall efficiency and longevity. Suction driers are usually installed in the suction line of a refrigeration cycle.


What is the suction pressure required for submersible pumps?

10 psi