0
What else can I help you with?
An uniformly distributed load is one which?
A uniformly distributed load is one which the load is spread evenly across the full length of the beam (i.e. there is equal loading per unit length of the beam).
Why hollow shaft is used for propeller shaft?
Because the load taking capacity of hollow shaft is more as the load per unit area is lesser due to the lesser cross sectional area.
How is a three way hydraulic valve used?
The hydraulic three-way directional control valve is designed to operate an actuating unit in one direction. It permits either the load on the actuating unit or a spring to return the unit to its original position.
What is a condensing unit contactor?
all it is is a switch that you will usually find 4 wires coming out of. how it works is you get a call for cooling from ur air conditioning unit and that sends a 24v signal to the contactor and it closes the curcuit and gives power to you condencer. control device to relay power to a load
Why should dc series motor can be operated for no load and light load?
dc motors can be operated at no load as well as at load condition.But by using the swin burns test the efficiency can be calculated at no load which is more benficial than load test.At industries this swin burns test is used because for load test we have to give separate supply for the load to run.In no load test that power is saved.
What is General formula for calculating compressive strength of concrete?
Load divided by area of load applied (Load per unit area)
What is the SI unit of load?
The SI unit of load is the Newton (N). It is a measure of force and represents the amount of force exerted on an object.
What are the units of measurement for current load and amperage?
The unit of measure for current load is amperage, or simply amps.
What is a distributed load?
A uniformly distributed load (UDL) is a load which is spread over a beam in such a way that each unit length is loaded to the same extent.
What develops vehicle load plans for unit equipment?
SDDC
Which element is responsible for the actual rigging of the sling load?
The Supporting unit is responsible for the initial rigging of a sling load. It is then the Load Master's responsibility to check the load for deficiencies before actually shipping it .
What is load density and is it demand load per covered area r installed load per covered area?
It is the maximum weight that can be safely loaded on a unit area..
Which is the most appropriate unit to measure the mass of a load of dirt?
kilograms
What is the unit load per square foot for dwelling units?
50 lbs
What is the stiffness of beam?
Stiffness is defined as the ratio of load per unit deformation.
Are trained at Air Mobility Command sanctioned courses to prepare check and sign unit aircraft load plans.?
air load commanders
Who is trained at air mobility command sanctioned courses to prepare check and sign unit aircraft load plans?
Air Load Planner
