0
What else can I help you with?
When should a reciprocating compressor not be energized?
the discharge service valve is closed.
What is back pressure?
Pressure going in the opposite direction in which it should be going.
How do you design hydraulic piston thickness?
Designing the thickness of a hydraulic piston involves considering factors such as the operating pressure, material properties, and safety factors. The piston must be thick enough to withstand the maximum pressure without yielding or failing, typically determined using stress analysis calculations, including hoop and axial stress. Additionally, the piston should account for fatigue and wear over time, which may require thicker sections in high-stress areas. Finally, the design should adhere to relevant engineering standards and regulations for safety and performance.
Where should the pressure enter a globe valve?
Over the seat
Is poor compressor can cause high head pressure in an air cooled condenser?
Poor compressor performance should result in low head pressure as the system cools better than the compressor can pump.
What should your water heater temperature be set at for optimal efficiency and safety?
The water heater temperature should be set at 120 degrees Fahrenheit for optimal efficiency and safety.
What should the hot water heater be set at for optimal efficiency and safety?
The hot water heater should be set at around 120 degrees Fahrenheit for optimal efficiency and safety.
Where should the discharge from a rupture disc be piped for venting on a low pressure chiller?
The discharge from a rupture disc on a low-pressure chiller should be piped to a safe location away from personnel and equipment, typically to a designated vent stack or exhaust system. It is essential to ensure that the discharge point is elevated and directed away from any occupied areas to prevent exposure to potentially hazardous materials. Additionally, the venting system should comply with local regulations and safety standards to manage any released substances effectively.
What should the low pressure be for a 404a refrigerant on a freezer?
18-20psig suction 250-270 psig discharge In freezers pressures are ok .I got it ,but the mention pressure of suction 18-20 discharge 250-270 at what temprature in centegrade it should be.
Why is my water heater overflowing and what should I do to address this issue?
Your water heater may be overflowing due to a buildup of pressure or a faulty pressure relief valve. To address this issue, you should first turn off the power or gas supply to the water heater. Next, try releasing some of the pressure by opening the pressure relief valve. If the problem persists, you may need to contact a professional plumber to inspect and repair the water heater.
What pressure should bike tires be inflated to for optimal performance and safety?
Bike tires should be inflated to the recommended pressure range indicated on the sidewall of the tire for optimal performance and safety.
What should I do if there is no shut off valve on my hot water heater?
If there is no shut off valve on your hot water heater, you should contact a licensed plumber to install one for safety and maintenance purposes.
What is the recommended temperature that a water heater should be set at?
The recommended temperature for a water heater is typically set at 120 degrees Fahrenheit to balance safety and efficiency.
What is the temp setting for hot water heater?
For safety, it should be kept below 120 degrees F.
Should I turn off the gas water heater when the water is turned off?
Yes, it is recommended to turn off the gas water heater when the water is turned off to prevent damage to the heater and ensure safety.
What is the highest temp setting for hot water heater?
For safety, it should be kept below 120 degrees F.
Should you open the pressure relief valve when you flush the water heater?
Yes, you should, it helps air get in to flush more quickly.
