Turbine maintain very good thrust force balance in IP rolling and high pressure and temp is not required in this.
An IP rating determines the level of ingress protectionthat the device is rated for. Ingress protection ratings determine how dust-resistant and water-resistant a given device is. An equivalent rating but is not likely to be common is a IK rating (which determines shock resistance)For every IP rating there are two digits - the first one being dust resistance and the second for water resistance. If there's a X on either digit, this means that the tests for this particular characteristic haven't been performed, rated, or there's no resistance.Most of the time you will see ratings like IP67 or IP68 - this means that (6) is dustproof and (7) or (8) is waterproof at somewhere around 3 to 5 feet underwater for up to about 30 minutes.
A phase current is the current passing through a phase, whereas a line current is the current flowing through a line.In the case of a balanced delta-connected load, IL = 1.732 IP. In the case of a balanced star-connected load, IL = IP.For unbalanced loads, these relationships don't hold true, and must be individually calculated.
it's the thermal expansion in the casing of hp or ip turbine can be noticed by journal or thrust bearing when moving <<
dn/dt acts: 1)gcb open. 2)Turbine speed reference is less than 2800. 3)TSE margine less than 30k. 4)Actual speed is lees than 2800 5)ip valve passing during rolling
BECAUSE IF YOU DIDN'T TEMPERATURE AND PRESSURE DROPS WOULD ALREADY BE TOO BIG TO ALLOW 2 EXTRA STAGES OF TURBINES (IP AND LP'S). EVIDENTLY TO RE-CIRCULATE STEAM BACK TO BOILER AND ON TO IP TURBINE IS MORE COST-EFFECTIVE (I.E.: MAKES YOU GAIN MORE MONEY) THEN PERHAPS NOT BEING ABLE TO ADD ANOTHER 2 STAGES BUT ONLY ONE (I.E.: IP). THIS WAY YOU CAN MAKE SURE TO EXPLOIT ALL ENERGY OF THE STEAM FLOW. IF YOU DIDN'T REHEAT LOSSES WOULD BE GREATER THAN GAINS pleas be more clear in your answer and tll mw th benifet of the hp & lp glands
10.50.1.22
go to this website: http://whatismyipaddress.com/
Menu > Configure Device > I/O > Embedded JetDirect Menu > TCP/IP > Manual Settings > IP Address
only if you've done something that forced others to find your IP!so the answer is yes they can!
The IP address could be anything, since it is assigned as a function of connecting to a network. If the printer is connected to the network, you can find the current IP by printing a configuration page. Check the printer manual for specific procedure to print the configuration page.
you can use cmd prompt by typing cmd in run on xp vista and 7 for local and for wide area you can use any ip site such as ipchicken.com or whatsmyip.org
This is known as IP spoofing, and it can be done to a degree.
If you meant DEDUCT (as in subtract) then nobody can deduct you from an IP Address!!! If you meant DETECT (as in finding out) then yes, it can be done.
Ip spoofing is done by modifying the source address of a ip packet from where it is initiated and spoofing another ip address of trusted host and sent to the destination selected as a victim. There are many application program available in the website through which we can spoof an ip address.