By putting deaerator at height, vapour doesn't form at the suction area of feed water pumps so cavitation phenomenon in the impeller can be prevented.
also to get NPSH.
A source of gamma radiation is placed on one side of the weld, and a photographic film is placed on the other. Bubbles and weak points will appear on the film.
Cuticle
bridges
You want the rupture disk located at the LP exhust side of the steam turbine. This is placed here to prevent over pressure of the condencer in case loss of vacuum occurs. It is not placed in the condencer because the condencer is not rated for pressure.
paita fhud ansere nani oe...
Your question is very Bad should you know the dearator in water cycle and turbine in steam cycle
Mostly clay is placed in a kiln.
You can generally put them where ever you want, but it the height placed at depends on the height of the person hanging it.
can remove hydrocarbon safely
jews
remain the same
Mostly Pop or Rock
Believe they can be placed just along side one another. By code, the height is 12 inches above floor.
The recommended height for chair rail installation is typically between 30 to 36 inches from the floor. Chair rail should be placed at a height that is visually appealing and practical for protecting walls from chair backs and other furniture.
It is placed at some height and a clean place or stand called Rahal.
they are placed in the tall class and older
The minimum height of the mirror should be equal to the height of the man's eyes, which is half of his total height. Therefore, the minimum height of the mirror should be 0.7m.