This question is dependent on the exact type of liquid. For example as it cools to freezing ice is actually less dense than liquid water. This is the reason for ice having the ability to float.
An air condenser takes in the surrounding air(at about 45-50 degree Celsius). The vapor at high pressure enters the condenser and accepts the latent heat of condensation from the hot airthereby rejecting heat to condensing coils. The vapor then becomes liquid.
Induction pump is a term used to describe any type of pump that depends on electromagnetic induction for its operation. These pumps are often used for liquid alkaline metals that are expected to reach temperatures between 800 and 1000 degrees Celsius.
Liquid is used in hydraulic systems.
It is fitted on discharge line after condenser, where the gas enters in liquid forms.
'Liquid Hold-up' in a distillation column refers to down-coming liquid (liquid traffic travelling down the column) becoming trapped in the column's packing material. Packing material is used in distillation columns to increase the contact efficiency between the down-coming liquid stream(s) and the up-flowing vapour stream(s). The packing materials do this by increasing the surface-to-volume ratio over which the vapour and liquid streams come into contact in order to promote separation between the more volatile and less volatile components in the column. The down-coming liquid can become trapped in the packing material for a number of reasons. One example is when liquid becomes trapped in crack formations or fractures of the packing material (which can occur during normal or non-steady state column operation). When the liquid becomes trapped in these cracks/crevices, contact with the up-flowing vapour stream becomes non-existent and the liquid is literally 'held up' from travelling down the column.
Yes, basically. The density will change, but in the case of a liquid, the change is quite small, for most practical purposes.
Liquid.
liquid
chemicals with temperatures 0f 38 degree Celsius below 0
Liquid state
The temperature of the fluid
Hydrogen bonds in water are much stronger than in ethanol. For the same reason the density of the liquid is also higher.
0 to 4 degree celcius
liquid
Its physical state is LIQUID
pure sodium melts at 97 degree celsius and boils at 882 degree celsius but no idea of evaporating temperature.......
The triple point of water is zero degree Celsius this is because 1)zero degree Celsius is the melting point of ice. 2)water changes from liquid to solid in zero degree Celsius.