0
What else can I help you with?
What is a wrist plate?
A wrist plate is a swinging plate in a steam engine, bearing two or more wrists, used for operating the valves.
What is the cpt code for a wrist mri?
73222 - MRI any joint of upper extermity, with contrast 73221 - MRI any joint of upper extermity, without contrast
Can you have an MRI with a steel plate in your head?
No u can't. An MRI is done by a giant magnet.
If I need mri of shoulder and have plate in wrist and leg stents can I have MRI?
You can probably have an MRI but the doctors will want to check out a few things before they do it. Stents are normally made from non-feromagnetic metals and so should be fine they will be able to check what type of stent you have in your medical records but my choose to confirm this with further testing. Metal plates that have been in place longer than 6 weeks and have become fused to the bone are fine also. They will probably want to confirm that the plate is well fused so it will not move once you are inside the magnet of the MRI scanner perhaps using a standard x-ray.
Is a aluminum pie plate a element?
is element
Is a aluminum pie plate an element?
is element
What is the best material for a wrist splint?
A wrist splint is used to stabilize or immobilize the wrist joint. The materials used for a wrist splint vary; some are quite hard such as a plastic splint, while others are quite soft such as an aluminum splint.
What is the weight of aluminum plate .250x12x12?
3.53 lbs.
How much does plate aluminum weigh?
It depends on the length and width of the plate, and the thickness. A 12 x 12 inch piece of plate aluminum which is 1/2 inch thick has the same length and width as a 12 x 12 inch piece which is 1/4 inch thick, but the 1/2 inch piece will weigh twice as much.
How do you polish aluminum plate?
To polish an aluminum plate, start by cleaning the surface with a mild detergent and water. Then, use a metal polish such as aluminum polish or a mixture of vinegar and flour to scrub the plate in small circles until the desired shine is achieved. Finally, rinse off any residue and buff the plate with a soft, dry cloth to bring out the shine.
What is the density of mic 6 aluminum tool plate?
The density of MIC 6 aluminum tool plate is approximately 0.0975 lb/in^3 or 2.7 g/cm^3.
What is the SIC code for aluminum foil manufacturing?
Establishments primarily engaged in manufacturing plain aluminum foil are classified in SIC 3353: Aluminum Sheet, Plate, and Foil.
