I have exactly the same as that. I got my retainer a few weeks ago and the top one is fine but the bottom one leaves this line and sometimes a cut or ulcer. It also hurts a lot when I put it in. I guess this is normal!
When you have braces for a certain amount of time you are required to wear a clear or wire retainer. They keep your teeth from moving. So say you got your braces off and you refuse to wear a retainer or you just don't want to, your teeth will move and then you have to get braces again. Your retainer doesn't have to be in very long.
Yes you can wear clear retainers to school regardless of what the dress code says, you are wearing clear retainers not jewellery and retaining your piercings are none of the school's business. Bottom line if your parents allow you to have piercings then that is between you and your parents, you wear retainers and not jewellery in your piercings at school to comply with the dress code, enough said.
Yes just make sure that it is very well line with grease proof, this is so that you can remove it easily!
Yesit's normal. If it wasn't, the retainer wouldn't have been made like that
An isolation tool set in the casing or liner that enables treatments to be applied to a lower interval while providing isolation from the annulus above. Cement retainers are typically used in cement squeeze or similar remedial treatments. A specially profiled probe, known as a stinger, is attached to the bottom of the tubing string to engage in the retainer during operation. When the stinger is removed, the valve assembly isolates the wellbore below the cement retainer.
The purpose of the garage door bottom seal retainer is to hold the bottom seal in place along the bottom of the garage door. This helps to prevent drafts, debris, and pests from entering the garage, as well as providing a barrier against moisture. The retainer contributes to the overall functionality of the garage door by helping to maintain a secure and insulated environment within the garage.
Remove the door and window handles, then all screws you can find. Then the retainers on the sides and bottom then when all OS loose, pull out on the bottom and push in on the top to disengage from the door. You need special tools for the door handle and retainers available at the parts store..
As long as it's only 1 night, you're fine.
Remove the window and door handles, then all of the screws you can find, then the retainers on the sides and bottom of the door. You need a special tool for the retainers and maybe the handles. http://neons.org/howtos/door/
ewfdeaswfaeswfdaeswfd I returned just an hour ago from our Ortho's office to have an impression made of just my daughters LOwer teeth. She lost 1/2 of her essix retainer. It cost 200.00 just for the bottom half.
Take the door and window handle fff then all of the screws you can find. Some are hidden pretty good. Then the retainers on the sides and bottom of the door. Special tools required to remove the handles and retainers avalilable at the parts store. When the panel is loose, pull out on the bottom and push in on the top and raise it up to disengage from the door.
93 Chev S-10 Pickup Replace Headlight(NON expert -( shade tree mechanic my 1st attempt, and it went nice & smooth)Lift the hood. Turn off Headlights (duh Unplug wire from engine side of headlightFrom the front of the headlight, remove two screws at the BOTTOM of the 'retainer frame' (my term) that holds the headlight unit in. Take care not to drop the screws. The retainer may or may not keep them with the retainer frame.Remove NO screws at the side. Gently pry rotate bottom of frame up till bulb unit can be pulled forward. I 'think the retainer frame will come out also - cannot recall. Basically it latches from the top, and is fastened, by two screws, at the bottom.Replace bulb, replace retainer frame (top first, then screws at bottom), replace plug at rear of bulb unit.