0
What else can I help you with?
is there a way to tile over plywood on a bathroom floor?
You would be better of removing the plywood floor completely - and tiling over the original surface.
How much does it cost to replace floor boards with plywood?
about 3.50
What are the best practices for using plywood for a bathroom floor?
When using plywood for a bathroom floor, it is important to choose a high-quality, moisture-resistant plywood to prevent warping and damage. Ensure the plywood is properly installed with a gap between sheets for expansion, and seal all edges and seams with a waterproof sealant. Finish with a waterproofing membrane and tile or other waterproof flooring material for added protection. Regularly inspect and maintain the floor to prevent water damage.
How much plywood do you need to replace the floor of a 15 x 11 room?
I think Approximatly 6 sheets of 4x8 plywood
What are the best materials to use for the bathroom subfloor?
The best materials to use for a bathroom subfloor are typically plywood or cement backer board. These materials are durable, moisture-resistant, and provide a stable base for the bathroom floor.
What is the labor cost to remove and replace a plywood floor?
$ 5 per square ft. + materials.
Can put cement on a plywood floor?
How much? what kind of plywood floor? Why do you need to do this??
How can I replace the shower floor in my bathroom?
To replace the shower floor in your bathroom, you will need to remove the old floor tiles or material, clean the area thoroughly, measure and cut the new floor material to fit, apply adhesive or mortar, and then install the new floor material. Finally, seal the edges and allow the floor to dry completely before using the shower.
Would you rather...Lick the dirty trash can or the bathroom floor?
bathroom floor
How do you raise a sagging floor?
If you want to raise a sagging floor, you can put a piece of plywood on the floor. You can then add new flooring over the piece of plywood.
How can I level a sloping floor using plywood?
To level a sloping floor using plywood, you can first identify the low points on the floor. Then, cut plywood shims to fit those areas and place them underneath the plywood subfloor to raise it to the desired level. Secure the plywood shims in place using construction adhesive and screws. Finally, cover the entire floor with a new layer of plywood to create a level surface.
What is the recommended plywood thickness for floor installation?
The recommended plywood thickness for floor installation is typically 3/4 inch.
