answersLogoWhite

0

A circular saw won't cut wet wood as well as it will dry wood but, it will cut. Avoid using a fine-tooth blade because it will tend to load and bind. Take a break from time-to-time to clean out the teeth. A brass detailing brush (looks like a toothbrush) will do a good job for cleaning the teeth.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Can you cut drywall with a circular saw?

Yes, you can cut drywall with a circular saw. Make sure to use the appropriate blade and take necessary safety precautions.


What is the maximum depth of cut that can be achieved with a circular saw?

The maximum depth of cut that can be achieved with a circular saw is typically around 2-3 inches, depending on the size and type of the saw blade.


How can I use a circular saw to cut a 45-degree angle?

To cut a 45-degree angle with a circular saw, you can adjust the saw blade to the desired angle using the bevel adjustment on the saw. Then, carefully guide the saw along the marked line to make the cut. Make sure to wear safety goggles and follow all safety precautions while using the circular saw.


How do trees get cut down?

With a saw


When trees get knocked down where do they go to be cut into planks?

Trees that are cut into planks are cut at saw mills.


What is the maximum cut depth of a circular saw?

The maximum cut depth of a circular saw is typically around 2-3 inches, but can vary depending on the specific model and blade size.


Is it possible to cut concrete with a circular saw?

Yes, it is possible to cut concrete with a circular saw that is equipped with a diamond blade specifically designed for cutting through hard materials like concrete.


Is a hole saw a circular saw?

"Yes, a hole saw is a circular saw. It is primarlily used to cut through thin materials and is used in a drill. Hole saws, or circular saws, are used to cut wood, plastic, concrete, or stone, depending on the type you have." A hole saw refers to the bit. Round bit like a piece of pipe, used in a drill, that cuts a hole and leave a donut or plug from the hole instead of an auger or butterfly bit that chips out all of the wood in the hole. A circular saw is the saw that uses a flat circular blade to cut in a straight line.


How Does a circular blade go through the wood?

The teeth on a circular saw are set to cut and advance through the cut surface as the saw is pushed. This is possibly the most common and useful tool on any building site.


A type of cut often made with a circular saw is called what?

Cross cut or rip cut depending on which direction you go.


How can thin strips of wood be cut without a table saw?

Thin strips of wood can be cut without a table saw by using a hand saw, a circular saw, a jigsaw, or a band saw. These tools can be used to carefully and accurately cut the wood into thin strips.


How to cut a 4x4 with a circular saw?

To cut a 4x4 with a circular saw, first measure and mark the cut line on the wood. Secure the 4x4 to a stable surface using clamps. Adjust the depth of the circular saw blade to slightly deeper than the thickness of the wood. Turn on the saw and carefully guide it along the marked cut line, applying steady pressure. Remember to wear safety goggles and follow all safety precautions while using power tools.