No. Use the putty.
You can use silicone as a substitute, but plumbers putty is simpler and far easier to clean up. 100% SILICONE
Oils from putty soak into and discolor marble. Putty not used when putting pipe together.
To open caulk properly, use a utility knife to cut along the edges of the caulk line. Then, use a caulk removal tool or a putty knife to scrape away the old caulk. Clean the area thoroughly before applying new caulk.
Put putty under outer edge of faucet base and fasten to sink. Remove excess putty after fastening faucet.
The best way to remove silicone caulk effectively is to use a caulk remover solution or a specialized caulk removal tool to soften the caulk and then carefully scrape it away with a putty knife or a caulk removal tool.
No, plumber's putty should not be used on marble surfaces as it can potentially stain or damage the marble. It is recommended to use silicone caulk specifically designed for marble or other sensitive surfaces when installing faucets in marble sinks or counter-tops.
To effectively seal a sink drain, you can use a plumber's putty or silicone caulk to create a watertight seal around the drain. Apply the putty or caulk around the edges of the drain before installing it, then tighten the drain in place to secure the seal. Make sure to wipe away any excess putty or caulk for a clean finish.
The best putty to use for this job is simple glazing putty. This is considered to be far easier to work with than caulk. It also lasts longer and will not shrink with time.
The wax rings are preformed and cheaper and will not dry out as putty will.
The most effective method for removing caulk from surfaces using a chemical caulk remover is to apply the remover according to the manufacturer's instructions, let it sit for the recommended amount of time to soften the caulk, and then use a putty knife or scraper to gently remove the softened caulk.
The recommended dry time for plumber's putty is typically around 24 hours before it is fully set and ready for use.
To use plumber's putty for sealing a sink drain, first clean the area around the drain. Roll the putty into a rope shape and apply it around the drain opening. Press the drain into place and wipe away any excess putty. Allow it to set before using the sink.