How do I build a canopy bed?

Answer 1

A canopy bed, or four poster, is basically just a bed with a large frame around it. From the frame you can hang curtains or drapes of any kind, or perhaps mosquito netting if the climate is suitable.

* Start with a basic bed, double size, at least, and preferably with a wooden leg at each corner, so you can easily attach the uprights. * Decide on the height and buy suitable lengths of wood. * Don't make it too heavy, but strong enough to support your drapes.

* Buy enough to include supporting angled pieces at the top corners. * Buy simple angle brackets to join the wood at the top. * Drill and screw it all together.

* Handle it very carefully, as it will be fairly flimsy till you have it attached to the bed legs. * Drill and screw the uprights onto the bed legs. It is best to have the uprights touching the floor. * Hang your curtains or netting just as you would attach curtains to a window.

Answer 2

If the rails are hook on then slide them into the slots on the headboard and footboard. If it's bolt/screw together then use or get the required hardware to assemble. Always remember that the slats will have to make the distance between the two sides and will rest on the sides of the rails, so make sure the rails are as far apart as the slats are long. If it is still all too overwhelming go to a furniture store where they have a bed that is comparable to yours and ask to speak with a service tech to get their input on how their bed is assembled. If it is still too over whelming offer the service tech a paying job to come to your residence and assemble it for you. Your question is really too vague to give just one answer since all beds are not made the same way each time.

Answer 3

How to Build a Platform Bed

Platform beds are easy to build, even if you don't have much experience with woodworking. A simple frame covered with plywood, platform beds are versatile and can be built as high or low as you prefer. Box springs aren't usually used with platform beds, which makes them ideal for those with only a top mattress. Sleek and modern, platform beds are perfect for simple, classic decor. Follow these steps to build your own platform bed.

Measure Your Mattress and Cut Your Lumber

First, measure your mattress. These measurements will be the dimensions of the frame of your bed. Use 1-inch lumber for the frame; you can make the frame as low as four inches or as high as 12 inches. Cut the lumber to the dimensions of the mattress.

Put the Frame Together

Apply wood glue to the edges of your frame. Nail the frame together to create a large box. Measure the interior dimensions of the width of the box and cut two boards of this size for braces. Glue and nail the braces inside the frame to create three equal-sized sections inside the frame.

Cut and Paint the Platform

The platform, which will be screwed on top of the frame, should be larger than the frame. The exact size will depend on how much overhang you want. Use 1/2-inch or 3/4-inch plywood for the platform. Cut it to the dimensions you want and paint or stain it. To save time and materials, paint only the outside edges of the platform, since the bed will cover up the center.

Paint and Move the Frame Inside

Paint or stain the outside of the frame. Allow it to dry thoroughly, then carry it inside and position it where you want it.

Attach the Platform

Use 1- to 1-1/4-inch screws to attach the platform to the frame. If you want to trim the platform, attach the trim with finishing nails. Put your mattress on the platform and make your bed.