0
How do I put the pull rope to start the weed eater lawn mower back in it and reconnect it it came out?
take the recoil off the weedeater, turn the part that holds the rope (it's the round wheel looking thing, usually white) until the hole lines up with the recoil hole. Turn it in the direction of the spring tensioning not unwinding, push your rope thru both holes and pull it up and out the hole on the top side of the wheel and tie a knot of the end and then push it back into the holding area using a small screwdriver or similiar, then you will see a notch in that wheel. Pull a portion of the rope up thru that notch (leaving most of it hanging out) and turn the wheel until the spring tightens all the way, It will twist your rope while your doing that, but just unwind it as needed, after the spring is as tight as in can be, let go of your rope. Make sure you have the pull handle in place!!!! If you don't already have the handle on, let it recoil slowly and when all the rope is inside, pull some back out and install your handle. Make sure to have some tension on it if you want it to hold up staight and not hang down/loose.
What else can I help you with?
When you pull start your lawn mower the cords whips back hard?
check the flywheel key. it sounds like it has sheared and will need to be replaced
Where is the kill switch on a push gas mower?
Most mowers unless electric have a lever that works as a throttle/choke to start your mower. If you just pull back on the lever till the throttle/choke no longer allows gas to the engine this usually shuts it off.
What is the occasion of church homecoming?
To bring back old members and to reconnect
What could cause a Chevy S-10 pick up to not start after you've changed ignition switch?
Did you reconnect the batt.? The computer might need to be reset. Push it to start it once and things might go back to normal.
How do you change poulan pro riding lawn mower oil?
One should first start the mower and let the oil get warm. Doing this will ensure that not much of the old oil is left in the tank. Next place an oil pan under the mower to catch the oil and then pull the plug pin. Let the oil drain out and then put the cap back in place. Refill the mower with new oil and the job is done!
How can I reconnect a garage door that has become disconnected?
To reconnect a garage door that has become disconnected, you can start by checking the tracks and rollers for any obstructions or damage. Then, manually lift the door back into place on the tracks and secure it with the proper hardware. Finally, test the door to ensure it is functioning properly before using it again.
When do you recharge the battery on a Toro keystart recycler lawnmower. Lost owners manuel. Also back wheel height adjustment will not stay in place?
how do you replace battery on key start mower
How can you get your internet connection back to its top speed?
you can disconnent and then reconnect and it should go faster
Give you ideas for church homecoming program?
To bring back old members and to reconnect
Re words that mean back or again?
reclaim reconnect resume return restore
Why does a new Briggs and Stratton 175cc lawn mower engine not restart when it is hot?
If its a new mower take it back to where you bought for warranty If you mess with it you will forfeit your warranty.
Why does Great Dane lawn mower start but stalls as soon as you back the choke out?
By backing the choke out I assume you mean turning it off. If it stalls when the choke is off but runs while it is on then you have an air leak somewhere
