To change the deck belt on a Mostt1000 professional DJ turntable, first, ensure the turntable is unplugged. Remove the platter by lifting it off the spindle, then locate the old belt around the motor pulley and platter. Carefully remove the old belt and replace it with the new one, ensuring it is properly seated on both the motor pulley and the platter. Finally, reattach the platter and plug the turntable back in to test its functionality.
if the turntable is not spinning at all then either the belt snapped or got so loose it fell off or if the table still spinns it might take a second to start up and will sound slow and playing a 45 will not sound right at all
If your dual turntable is not working on the 33 speed setting, it could be due to a belt issue, a motor problem, or a calibration error. Make sure the belt is properly connected and not worn out, check the motor for any signs of malfunction, and ensure that the turntable is calibrated correctly for the 33 speed setting. If these steps don't resolve the issue, you may need to seek professional repair services.
I've never had one wear out.
My BIC turntable accomplishes this with a different sized belt pully. They have a U.S. diameter (60 HZ) and a U.K. diameter. Their parts department stock both. Joe
Soak in very hot water for 10 minutes.
The Gemini VINYL2MP3 Belt Drive USB Turntable is an excellent choice. It is affordably priced, offers USB capabilities, and is from Gemini, an excellent brand.
To fix a turntable, first identify the issue—common problems include a faulty belt, misaligned cartridge, or a weak motor. Start by checking and replacing the drive belt if it's worn or broken. Next, ensure the cartridge is properly aligned and that the stylus is clean. If the motor isn't functioning, inspect the power supply and wiring for any faults before considering a professional repair.
This repair is best left to a professional.
This is a job best left to a professional.
Surely the problem is more elaborate than that... Simply place the dishpan on a turntable (a flat platform that is mounted to a shaft and is able to turn on bearings), connect a pulley to the shaft of the turntable and connect a belt to a motor that will turn the turntable... then the dishpan will turn.
The belt part is attached to the seat frame and comes out with the seat. The track part is better left to a professional.
unless you are a professional you dont you just have to pay because its in your engine