To find a joist in a wall, you can use a stud finder, which detects changes in density behind the wall surface. If you don't have one, you can knock on the wall; a solid sound indicates a joist, while a hollow sound suggests a space between them. Joists are typically spaced 16 or 24 inches apart, so measure from a known point to locate them accurately. Additionally, you can look for visible signs, such as nails or screws, on the wall surface.
joist
Floor joist or ceiling joist? Floor joist have a board on the end all the way along the side of the building called a rim joist. Like the cross bar on the top of a T. Ceiling joist are nailed down into the top plate of the wall and to the rafters where possible.
it is the board that is put on the top of the basement wall and then the side wall is built above that.adding foam to this joist helps to reduce air infiltration up to 25 percent.
beam transfer loads from the joist to the wall or column where it supports..
Nails. If they cannot be placed on top of a wall or beam a joist hanger is required as well.
A wall joist in a building's structural framework provides support and stability to the walls, helping to distribute the weight of the structure evenly and prevent sagging or collapsing.
In balloon construction, the rim joist is fastened to the wall framing using metal fasteners or wood screws. First, position the rim joist flush against the ends of the vertical wall studs. Then, secure it by driving screws or nails through the rim joist into the studs, typically spaced every 16 to 24 inches apart. Additionally, using construction adhesive can enhance the connection and provide extra stability.
Not sure what you mean? floor joist span table???
Drill a hole large enough and pull the cable through. The hole must be 1-1/2" from the edge of the joist to prevent nails or drywall screws from penetrating the cable. If the hole is less than this distance, a nail plate must be installed over the edge of the joist so when the wall covering is added, a screw or nail can't penetrate the wire. Any hole drilled through a joist must be no more than a fifth of the depth of the joist and should be as near as possible to the centre of the joist. Holes bigger than 30mm are not recommended without specifically designed additional strengthening to the joist.
that would all depend on what is under that wall. If it is running along a floor joist that is properly supported, then I would do it
Do you mean what can soft wood be used for. Here are some uses. Roof trusses/ floor joist/ ceiling joist/ stud partitions/ timber flooring/ wall strapping/ linning boards internal finnishing. ect
The ceiling joist span chart provides information on the maximum distance a ceiling joist can span without additional support. This helps determine the appropriate spacing and size of ceiling joists for a given room or structure.