a weaved valley: you run one shingle at least 6inches past the valley onto the opposite side of the valley from each side all the way up
alternating them each time so they overlap like a weave on top of each other This does not work well in pitches are different and often look sloppy. keep in mind that the top of the shingle has to be 6 inches past the valley center. Another thing to keep in mind is to be really careful of your nail pattern, do not nail in the valley keep nails above the rain channels skip a nail if too close (6" away at least)
I like a clean cut valley, to do this run the shorter rafter section first, unless you are running a flatter section like a porch then run the flatter section first. you will run all the way up on the first side lapping a min of 6 inches past the center of the valley at the top of the shingle. Keep nails away from valley center by about 6" or more, and make sure to keep nails above rain channels only, skipping if necessary. Keep in mind you do not want a seam too close to a valley. Now you run the other side running till the top of the shingle is just short of the center line of the valley. Take a chalk line and pop a line 1 inch short of the center of the valley, cut with a hook blade being careful not to score through the shingles below.also when there are two different pitches the flatter of them will require one or more added to keep center of vally
Shingles curl up at bottom of shingle.
form_title= Asphalt Shingles form_header= Put a new roof on your home with asphalt shingles. What color shingles do you need? *= _ [50] What size shingles do you need?*= _ [50] Are you replacing a whole roof?*= () Yes () No How old is the roof?*= _ [50]
Yes, the shingles have been blown off the roof.
The shingles on my roof are beginning to wear out. Do you know where the best place to buy roof shigles is?
We need to tear out a spot on our roof. How difficult is it to remove and replace roof shingles on our own?
To start shingles on a roof, begin at the bottom edge and work your way up, overlapping each row of shingles to ensure proper water drainage. Use roofing nails to secure the shingles in place, following the manufacturer's instructions for spacing and placement.
To put shingles on a roof effectively and efficiently, start by preparing the roof surface and gathering the necessary tools and materials. Begin at the bottom edge of the roof and work your way up, overlapping the shingles to prevent leaks. Use proper nailing techniques and follow manufacturer instructions for best results.
Yes, the shingles blew off the roof during the storm.
roof shingles
To install roof shingles properly, start by preparing the roof surface, laying down a waterproof underlayment, and then starting at the bottom edge of the roof and working your way up. Nail the shingles in place, making sure to overlap them correctly and follow the manufacturer's instructions. Finish by adding flashing and ridge caps for a secure and weatherproof installation.
To lay shingles on a roof effectively and efficiently, start by preparing the roof surface and installing underlayment. Then, begin laying the shingles from the bottom up, overlapping each row to prevent leaks. Use proper tools and techniques to ensure a secure and uniform installation. Finally, trim any excess shingles and seal the edges for a finished look.
Slate which is a type of stone is used for the roof tiles instead of shingles. It splits in thin sheets and is nailed to the roof the same as regular asphalt shingles.