How do you make a homemade strap-on dildo?

Answer 1

Go to Hobby Lobby. Buy 1" elastic band and 1/2" elastic band. Get some snap fasteners and some metal o rings. Use the 1" for the top of the harness, you will need her to let you measure it around her waist, so that it will be snug. Make loops around the o ring that you need and fasten it with the snap fasteners. Then try it again and measure the length of the under straps (1/2" elastic band). Connect the smaller under bands to the o ring and leave them long. I used 2 bands, but you could use 1 band. Then while still on, pull the small straps back to the hips and mark a spot on larger band to connect to. Connect small bands or band to larger band with snap connectors. Test fit. If that is okay, then if you need a pad, either buy something soft or use something around the house. We have used sock, padding, panties, etc. Cheap and really easy. No sewing required. Hope this helps. B

Answer 2

What we did, was buy some black 1 1/2" elastic and some 3/4" elastic bands. Get some snaps and a o ring. Measure the thicker elastic around the waist. Make sure it is tight. Then connect it to the o ring with the snaps. This way you can change the o ring if needed. Then measure from the o ring to the back of the harness between your legs. Snap these together and you have a harness that will hold a decent size dildo and is easy on/off. Hope that helps. I've made two and they work well, my wife likes this kind over the previous three we bought.

Answer 3

A homemade strap-on can be made by wearing a belt and taping a cucumber to it. Duct Tape is best as it holds firmest. Be sure to use the smooth end of the cucumber as the stem can cut the interior of an orifice.