How do you make a tight square bale using a Massey Ferguson 124 square baler?

Answer 1

run the twine through the eyelets and through the needles , which are the large arms that rise up . take that twine and tie to the rear of the baler,both of them and run them where the bale forms. next trip the wheel that ties the bale, and turn the baler by hand for one cycle. the twine will be tied now cut the excess twine that u tied to the rear of the baler from the needles and you are ready to bale .

Answer 2

First of all, get a copy of the Operator's Manual. On pages 10 and 11 it has the details for threading the tying mechanism. The manual reprint is available for $19.95 at the following website: www.binderbooks.com/implement.htm

Answer 3

both pieces of twine come out of the twine chute, then under the tensioner on the outside wall of the twine chunte, through the slack springs, down through the insulator, then one string goes to the near side needle, and the other goes through the far side insulator, then threw the far side needle. Once they come out of the needles, tie them off to the round tubing at the bottom of the bailer.

Hope that helps!