How do you put warp on a carpet loom?

Answer 1

Well, darling, to put warp on a carpet loom, you first need to secure one end of the warp yarn to the loom frame. Then, you'll start winding the yarn around the loom's pegs or beams, making sure to maintain even tension throughout. Finally, you'll secure the other end of the warp yarn to the opposite side of the loom, and voilà, you've got yourself a beautifully warped carpet loom ready for weaving.

Answer 2

To begin using a simple loom, tie the yarn to the bottom rung, and wrap around the frame, with approximately a half-inch space between each wrap. Wrap from front to back on the top frame and from back to front on the bottom frame. Wrap the yarn between the notches on the shuttle, leaving enough room for the shuttle to pass through the shed. Twine the yarn on the shuttle over and under the thread on the frame. Using a wide-tooth comb, push the yard down on each pass. Continue on in this fashion. Finish off by cutting the yarn at the top and bottom of the frame. Tie the yarn into fringe for a clean, finished look, and to secure the thread.