The mollys are generally soft metal, so you could drill it out with a standard drill bit and then patch the hole.
You could also cut the bolt off flush with the floor and then drive it down below the surface of the floor.
They're not usually bottomed out in the hole and you can get them down deep enough to patch.
You put the screw back in the plastic, screw it in for a few turns & then pull the rest of the molly bolt out of the wall. It will leave a big hole that you need to patch & repaint.
remove shifter boot/ 4 screws to floor board remove nut from cross bolt install nut on opposite side of cross bolt and tighten nut cross bolt is tapered, this will remove cross bolt
To install a molly bolt properly, first drill a hole in the wall, insert the molly bolt into the hole, and tighten it with a screwdriver until it is secure. Make sure the molly bolt is flush with the wall surface for proper installation.
after you remove the bolt, the spindle that holds the top on , must Be remove by turning it counterclockwise, it is threaded through, the floor
You unscrew the large bolt on the trunk floor under carpet.
plate in floor next to footrest (RHD) - ALLEN KEY -TOP BOLT - BOTTOM BOLT FROM UNDER THE CAR
To use a Molly bolt effectively for hanging heavy objects on drywall, first drill a hole in the wall, insert the Molly bolt, and tighten it with a screwdriver. The bolt will expand behind the drywall, providing strong support for the heavy object. Make sure to follow the manufacturer's instructions for the specific weight capacity of the Molly bolt you are using.
Open the rear hatch. Remove the tri-fold floor, remove the lower floor. The battery is down there on your right. Remove the negative cable, then the positive. Remove the strap and/or bolt in connector. Remove battery.Reverse process to re-install.
The seats bolt to the floor. The bolts need to be removed, then the bolt holes will still be visible through the carpet.
The L shaped bolt used to attach masonry or concrete to wood is called and anchor bolt. It may also be referred to as an a lag bolt.
An anchor bolt is used to attach things or structures to concrete. Anchor bolts are used on all types of projects. They are used on dams and nuclear power plants.
To install molly bolts properly, first drill a hole in the wall, insert the molly bolt, and tighten it with a screwdriver until it is secure. Make sure the bolt is flush with the wall surface for a strong hold.