I tried to hop a curb into a parking pad we have next to our driveway. That seemed to do the trick for one side. Popped it right off.
All contour svt 's were 5 speed manual transmissions. No transmission dipstick.
With a brick.
I was looking at the 1998 and 2000 Contour SVT supplements and in both it shows the 2.5 liter V6 engine
check this link out
The PCV (Positive Crankcase Ventilation) valve on a 2000 Ford Contour SVT is located on the passenger side of the engine, specifically on the valve cover. It is typically found near the rear of the engine, connected by a hose to the intake manifold. To access it, you may need to remove some components or covers, depending on the layout and space in the engine bay.
chain
( No ) the Ford Contour is a front wheel drive vehicle
right outside the tranny
I was looking at one of Fords websites and it shows : For a 1998 Ford Contour SVT , 2.5 litre V6 engine : ( the Motorcraft FL-820-S engine oil filter is used )
According to the 1998 Ford Contour SVT supplement : The original tires were the ( Goodyear Eagle F1-GS , size P205 / 55 ZR-16 ) on 16 X 6.5 inch wheels
You need the last 6 digits of your VIN# and call 1-800-FORD-SVT. $40 will get you the Certificate of Authenticity
first jack the entire front of vehicle up remove left side tire and splash shield.. then using several extensions you can reach the top bolt from the left side it takes some tedious maneuvering but it beats the hell outta removing the A- frame and lifting the engine.. and if you can do it yourself it will have you a couple hundred in labor cost!