To repair a Howard Miller Barwick Floor Clock Model 4882 that runs but won't chime, first ensure that the chime mechanism is properly engaged by checking the chime selector lever, which may be set to "silent." If the lever is correctly positioned, inspect the chime weights and the mechanism for any obstructions or misalignments. Additionally, check for any worn or damaged gears in the chime assembly that may need lubrication or replacement. If the issue persists, consulting the manufacturer's manual or a professional clock technician may be necessary.
Check the back for kinks
Just bought a used Daniel Dakota Westminister wall clock and it does not chime.
To calibrate the Daniel Dakota Westminster Chime clock, first wind the clock fully. Then adjust the time to 5 minutes before the desired time and let the clock chime. You can fine-tune the clock by adjusting the minute hand to the exact time when the chime sequence ends. Repeat as needed until the chime matches the correct time.
I have a Walthram 31 day chime clock and on of the weights fell to the bottom of the clock. How do I fix it and why did it fall?
It depends on the clock; None of my clocks chime even once. A clock that rings the quarter hours (like the clock in the Palace of Westminster - aka, Big Ben) would chime 96 times per 24 hours. Some clocks only chime on the hours, which would be 24 chimes/day.
4 seconds
You cannot turn off the chimes on this clock
The Seiko QXH-series can chime on the hour, but you'll have to enable it first.
It may just be to old. You can still use it as decortion.
It takes 1.25 seconds for each chime so it will chime 72.5 times in 58 seconds
One of the weights is for the hands to rotate and the other is for the chiming bells. they do different tasks. When I wind mine up after it has 'run out' it will often chime straight away but it will never tick till the pendulum is activated.