Answer depends on voltage being used.
Volts x amps = watts
1000 watts = 1Kw
You have 200 amp welder.
Assuming you have 240volt power line to welder:
240Volts x 200amps = 4800 watts = 4.8Kw
A 50 amp welding machine requires a 50 amp welding plug, which is a specific type of electrical outlet designed to handle the high power needs of the machine.
A welding rectifier takes in the a/c output of a welding transformer, and the output is d/c. Used with old school welding transformers which were all a/c, in order to get d/c for use with low hydrogen rods etc.
1,000 milliamps = 1 amp 200 milliamps = 0.2 amp
Welding is done with a high current and low voltage. The voltage of a 500 amp welder might be 10 v so the power rating in that case would be 5000 watts.
In North America this size breaker could be used on a welding machine. A range in the home would use a 40 amp two pole breaker.
Depends on how thick the metal parts are, and how well the seams are prepped. You also need to consider the duty cycle of the welder if you're doing serial production or long welds.
Probably not. Some machines can be connected to a variety of voltage situations, most can not. An electrician could tell you if your machine is one of these. WHAT I HAVE IS A 220 VOLT 100 AMP SPEEDWAY SERIES. ITS LIKE THE MACHINE DOESNT WANT TO HOT ENOUGH. TRANSFORMER HAS DOUBLE MOVABLE CORE. You need a 110 to 220 volt transformer capable of providing at least 100 amperes on the 220 side. This transformer will pull more than 200 amperes from the 110 outlet. You may need an electrician to rewire your breaker panel and service connection.
Check the nameplate on the service panel. There it will tell you what the buss capacity is. On a 200 amp service nothing in the wiring configuration is allowed to be less than that the service rating. In the market there are 200 amp 42 circuit distribution panels.
The number of circuits you can have on a 200 amp service depends on the load of each circuit. As a general rule of thumb, you can have up to 40-50 circuits on a 200 amp service panel, but this can vary based on the specific requirements of your electrical system and local codes. It's important to consult with a licensed electrician to determine the appropriate number of circuits for your installation.
A typical deep cycle battery usually has amp-hour ratings ranging from 50 to 200 amp-hours.
When you refer to a 200 amp welder you are talking about the output side of the welder. What you have to do is find out what the input voltage and current of the welder is to calculate the size of a generator needed to operate the welder.
The maximum amperage capacity of a 400 amp meter base with two 200 amp disconnects is 400 amps.