I just got a quote this week from a professional contractor on tearing down 2 load-bearing walls in my new home. He said he would do 1 wall for $3600, and the 2nd wall for an additional $2600. Hope this helps!
depends on how big the wall is would help if you were more specific
It will cost about $550 to remove a non load bearing wall by a contractor. That amount is for a wall that is about 10 feet long and 8 feet high.
250.00 a load
This depends on if it is a load bearing wall or not. If it is load bearing, it supports the roof or higher story and cannot simply be taken out. Jacks must be installed before the wall is removed, and something else must be built in its place to handle the weight. If you don't do this you will regret it. With all the proper equipment this can be expensive, and depends on the job. If it is not a load bearing wall, not nearly as much. Removing a non-load bearing wall is a matter of removing any mechanical fixtures (lights/outlets/plumbing/heating), knocking the wall down, and then patching the hole where the wall itself was to blend the now joined room. It it is just a wall, I'd say around $20 for a sledge + paint & plaster. Please check that it isn't load bearing first, though. If you succeed in knocking out a load beaing wall your house may collapse. At the minimum you will do severe damage to the now bearing walls as the house settles into its new position.
It is recommended to consult with a structural engineer to determine how much of a load-bearing wall can be safely removed without compromising the structural integrity of the building.
a shiznet load
youll need software to down load,it doesnt cost much
The average 2002 Mercedes-Benz will bearing will cost $250 to replace. The exact cost of replacing a will bearing is dependent upon several factors.
The cost for the bearing only is between $45 to $90.00. Additional costs for labor can cost between $40 and $80.
a load of money
All exterior walls in a home are load bearing. The exterior walls on the gable end of your house do not bear much load, but the walls that the hip of the roof bear on carry your roof and ceiling joints. Interior walls are another story. Usually in a smaller one story home there is a wall that runs the midspan of the house that is load bearing for your roof and ceiling joints.
It cost me around $200