49 pounds
I just (8.30.09) weighed a few 4X4X8'. Pressure treated (.51 ground contact rated) were between 25 and 30# depending on their moisture content. To contrast, the weight of 2X4X8 (wet, sappy, .40 treated) was 16 # each, so the 4X4X8 should weigh 32# with the same moisture content. Obviously, the moisture content of the wood causes the largest variation, so realizing that, you can only estimate the weights to be "real heavy." This was done with a bathroom scale and standing the wood up.
Ah, creosote-treated lumber can be a bit heavier than untreated lumber due to the added chemicals. The weight can vary depending on the type and size of the lumber you're using. Remember, each piece is unique, just like a happy little tree!
The weight that a 4x4x8 can hold will depend on the type and quality of the wood used. As a general guideline, a Douglas fir 4x4 is rated to support around 900-1200 pounds vertically. However, for precise load-bearing calculations, it's recommended to consult a structural engineer.
A standard treated lumber 2x4x12 typically weighs around 30 to 40 pounds, depending on the specific type of treatment and moisture content. The weight can vary slightly based on the species of wood and the manufacturing process. Always check with the supplier for the most accurate weight for the specific product you are considering.
A 2 by 4 (lumber) will have a weight based on the density of the wood. Pine, fir, redwood, treated or untreated will have different densities.
A 2x4x8 spruce pressure-treated lumber typically weighs around 18-20 pounds. The weight can vary slightly depending on the specific moisture content and density of the wood.
A pressure-treated 2x8 that is 14 feet long typically weighs around 50 to 60 pounds. The exact weight can vary based on the wood species and the amount of treatment applied. Always check with the specific lumber supplier for precise weight information.
A treated 4x4x10' piece of lumber typically weighs between 40 to 50 pounds, depending on the moisture content and the specific treatment used. The weight can vary slightly based on the species of wood and the density of the treatment applied. Always check with the supplier for the most accurate weight for a specific product.
"Treated" lumber COULD have several meanings, but it usually means treated to resist rot and attack by insects. Early treatments included creosote (thin railroad ties). "Green" lumber was treated with Chrome, Copper, and Arsenic. Due to health hazards, wood a consumer would be likely to come in contact with (handrails, etc) are now treated with a Copper Boron mix. These woods are used for outdoor stairs, decks, docks, gazebos, etc.- anywhere you would have direct contact with the ground. In Hawaii, the Formosa Termite can do GREAT damage to lumber, so much of the house that is built in Hawaii uses treated lumber.
How much a surgery on lumber L4 L5
The weight a structure can support using 2 x 10 lumber depends on various factors such as the type of wood, the length of the lumber, and the spacing between the supports. In general, a 2 x 10 lumber can support around 600-800 pounds per linear foot. It is important to consult a structural engineer or building code regulations for specific weight capacity requirements.
it is a superior wood for decking, staying smooth and splinter free for years. Also, it looks much better than treated pine.